Sony KDL-50R450A Service Manual ▷ View online
KDL-50R450A 21
SECTION 4 - EXPLODED VIEW/PART NUMBER INFORMATION
NOTE: The components identified by shading and
!
mark are critical for safety.
Replace only with part number specified.
NOTE: The components identified by a red outline and a mark contain confidential
information. Specific instructions must be adhered to whenever these components are
repaired and/or replaced. (See Appendix A)
SCREWS
P/N
DESCRIPTION
KDL-50R450A
4-473-649-01
SCREW, +PSW M5X35
Plastic Stand to TV (4)
SCREW, +PSW M4X8
Lower Cover (8), Bottom Bracket
Left (4), Bracket Bottom Right (4)
2-580-600-01
2-580-592-11
Main Board (4), Power Supply
Board (6)
SCREW +PSW M3X8
Lower Cover to Speaker (4)
SCREW, +K M3X8 (FANW)
4-477-530-01
4-473-621-01
SCREW M3X3 NI
TCON Board (2), Source Cover
Left (3), Source Cover Right (3)
SCREW, +F STEP M4X8 (FANW)
Lower Cover (2)
4-477-529-01
AC Cover (1), Lower Cover (2)
SCREW +BVTP 3X10 TYPE2 IT-3
7-685-647-79
KDL-50R450A 22
ACCESSORIES AND PACKAGING
PART NO.
DESCRIPTION
4-473-649-01
SCREW, +PSW M5X35
(SCREWS TO ATTACH TABLE-TOP STAND TO LCD TV)
For product protection and safety reasons, Sony strongly recommends
that you use the screws provided with the TV.
CAUTION: These screws cannot be used to secure the TV
to the Wall Mount Brackets.
4-470-897-11
MANUAL, INSTRUCTION (ENGLISH VERSION)
4-470-897-21
MANUAL, INSTRUCTION (FRENCH VERSION)
4-473-650-01
BAG, NUT ASSEMBLY
4-470-900-11
GUIDE, QUICK SETUP (ENGLISH VERSION)
4-470-900-21
GUIDE, QUICK SETUP (FRENCH VERSION)
4-470-901-11
SUPPLEMENT (STAND INSTALLATION)
MISCELLANEOUS
PART NO.
DESCRIPTION
4-473-623-01
TAPE
4-473-644-01
TAPE GASKET
4-479-578-01
TAPE W25
4-479-577-01
TAPE W8
4-474-164-11
DOUBLE SIDED TAPE
3-299-071-08
FLYER, SAFETY
OPTIONAL ACCESSORIES
PART NO.
DESCRIPTION
4-414-470-01
SUPPORT BELT KIT
REMOTE COMMANDER
PART NO.
DESCRIPTION
1-492-065-11
REMOTE COMMANDER (RM-YD092)
SECTION 5 - ACCESORIES/PART NUMBER INFORMATION
KDL-50R450A A-1
Sony Corporation
Sony LCSC
Technical Services
Service Publications Department
9-883-538-01
English
2013GJ74WEB-1
© 2013.7
is a trademark of Sony Electronics.
Reproduction in whole or part without written permission is prohibited. All rights reserved.
APPENDIX A: ENCRYPTION KEY COMPONENTS
Encryption key components developed by Sony Corporation contain confidential information and shall be handled under the non-disclosure obligations provided
in the applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
pursuant to the following:
1.
In the service manual the Circuit Board(s) containing encryption key components shall be identified with a red outline and a .
2.
Only repair boards or components listed in the service manual shall be utilized for replacement and/or repair.
3.
Disassembly, decryption or reverse-engineering component(s) is strictly prohibited.
4. Any board in which the Servicer replaces an encryption key component must be placed back into the set it orignally came from and the replaced
defective component MUST BE DESTROYED. Boards cannot be swapped.
5. If a Circuit Board identified with a red outline and a in the service manual is deemed to be defective:
a.
and if a core charge is imposed and is covered under the product warranty, the defective un-repaired or modified board MUST BE RETURNED to
Sony.
b. and if the core charge is NOT covered under the product warranty, the defective un-repaired or modified board MUST BE DESTROYED.
6.
If a unit is destroyed (such as field scrap), the Circuit Board identified with a red outline and a in the service manual MUST BE DESTROYED.
KDL-50R450A A-1
Sony Corporation
Sony LCSC
Technical Services
Service Publications Department
9-883-538-01
English
2013GJ74WEB-1
© 2013.7
is a trademark of Sony Electronics.
Reproduction in whole or part without written permission is prohibited. All rights reserved.
APPENDIX A: ENCRYPTION KEY COMPONENTS
Encryption key components developed by Sony Corporation contain confidential information and shall be handled under the non-disclosure obligations provided
in the applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
pursuant to the following:
1.
In the service manual the Circuit Board(s) containing encryption key components shall be identified with a red outline and a .
2.
Only repair boards or components listed in the service manual shall be utilized for replacement and/or repair.
3.
Disassembly, decryption or reverse-engineering component(s) is strictly prohibited.
4. Any board in which the Servicer replaces an encryption key component must be placed back into the set it orignally came from and the replaced
defective component MUST BE DESTROYED. Boards cannot be swapped.
5. If a Circuit Board identified with a red outline and a in the service manual is deemed to be defective:
a.
and if a core charge is imposed and is covered under the product warranty, the defective un-repaired or modified board MUST BE RETURNED to
Sony.
b. and if the core charge is NOT covered under the product warranty, the defective un-repaired or modified board MUST BE DESTROYED.
6.
If a unit is destroyed (such as field scrap), the Circuit Board identified with a red outline and a in the service manual MUST BE DESTROYED.