Sony KDL-40HX720 / KDL-46HX720 / KDL-55HX720 / KDL-65HX720 Service Manual ▷ View online
KDL-40/46/55/65HX720(CH)
125
While pay attention to double sided tapes, put panel on to bezel assembly as below.
3. PUTTING PANEL ON TO BEZEL (65)
APPENDIX-2
(1)Put on upper side
(2)Put down
Care about positioning rib (L&R)
Lock to BEZEL’s hook with holding
like left picture .
If OK , there is a clicky sound .
NG way is below (just pushing from top )
like left picture .
If OK , there is a clicky sound .
NG way is below (just pushing from top )
Hold here
(edge of part)
(edge of part)
click
screw
NG way
1.Putting Panel on to bezel
(1) Put from upper side adjusting position to L/R side.
(2) Down panel on to bottom caring about fitting bezel position
ribs and panel cutout area.
2.Assembling “BRACKET, PANEL (65 VEG)” (13 pcs)
KDL-40/46/55/65HX720(CH)
126
APPENDIX-2
3. Screw “BRACKET, BTM(65A)” (2pcs)
screw
4. Assemble “BRACKET, TOP (L) and (R )” (2pcs)
Screw
(SONY screw)
(SONY screw)
assemble
<New panel>
Unscrew (CMI screw)
(2 pcs L and R)
(2 pcs L and R)
<Old panel>
Screw (
Please reuse above CMI screw (P/N: 4‐297‐159‐01) from new panel
)
*Don’t use any other screw.
(2 pcs L and R)
If Old panel should be sent to CMI , please send with this condition .
KDL-40/46/55/65HX720(CH)
127
OK to grab
(curling area)
(curling area)
OK to grab with care
(sharp edge area)
NG to grab
(sharp edge and
easy to deform.)
(sharp edge and
easy to deform.)
CAUTION TO SHARP EDGE OF REAR COVER(55)
APPENDIX-3
KDL-40/46/55/65HX720(CH)
128
OK to grab only pulled out
(sharp edge area)
OK to grab
(curling area)
(curling area)
OK to grab with care
(sharp edge area)
CAUTION TO SHARP EDGE OF REAR COVER(65)
APPENDIX-3
NG to grab
(sharp edge and
easy to deform.)
(sharp edge and
easy to deform.)