DOWNLOAD Sony KD-32DX100U Service Manual ↓ Size: 19.07 MB | Pages: 112 in PDF or view online for FREE

Using a narrow blade screwdriver lever off the 4 screw
covers from the rear of the set. Remove the 12 speaker grill
and  rear cover fixing screws. (See 2-3.)

Remove the speaker grills by holding top and bottom and
sliding  away from the set. Remove the ornamental plate
from the top front of the beznet by sliding to the right.
Remove the 5 screws indicated from the top front of the set.

Before completely removing the rear cover disconnect the
speaker connector which is located on the inside of the rear
cover.

Remove the rear cover by sliding backwards away from the
picture tube. Take care when removing the rear cover not to
damage the speaker cables [Disconnect the speaker
connector] as speakers are fitted inside the rear cover.

=>

=>

=>

=>

To remove lift the main bracket rear slightly and slide the
chassis away from the beznet. Ensure that the interconnecting
leads are released from their purse locks to prevent damage
being caused.

When refitting the chassis ensure that the main bracket is
located in the beznet guide slots before sliding the chassis
forwards. Refit the interconnecting leads in their respective
purse locks.

Using the slot on the rear left of the beznet position the
chassis as indicated to access the solder side. To gain access
to the underside of the boards follow the instructions on
page 18. [Removal and Replacement of the main bracket
bottom plates ].

To remove the G Board release the clips circled and ease the
board gently away from the support bracket. Removal of the
D Board follows the same procedure.

Remove the F1 bracket by removing the screw indicated and
sliding the bracket  away from the beznet.

Remove the H1 bracket by removing the screws indicated.
Release the two clips circled and ease the bracket out of its slot
in the beznet.

To remove the N Board shield, release the two fixing screws
and lift the shield vertically until it is clear of the chassis.

To remove the G1 Bracket release the four clips (two on each
side of the bracket) and carefully lift away from the chassis.

To remove the F1 board release the two clips circled and ease
the board gently away from the support bracket.

To remove the H1 board release the two clips circled and ease
the board gently away from the support bracket.

Note : Removal of the H3 Board follows the same procedure.