DOWNLOAD Sony HDR-FX1000 / HDR-FX1000E (serv.man3) Service Manual ↓ Size: 1.02 MB | Pages: 81 in PDF or view online for FREE

Model
HDR-FX1000 HDR-FX1000E (serv.man3)
Pages
81
Size
1.02 MB
Type
PDF
Document
Service Manual
Brand
Device
Movie / SECTION 6 ADJUSTMENTS
File
hdr-fx1000-hdr-fx1000e-sm3.pdf
Date

Sony HDR-FX1000 / HDR-FX1000E (serv.man3) Service Manual ▷ View online

6-1
HDR-FX1000/FX1000E_ADJ
SECTION 6
ADJUSTMENTS
1.
Before starting adjustments
EVR Data Re-writing Procedure When Replacing Board
The data that is stored in the repair board, is not necessarily correct.
Perform either procedure 1 or procedure 2 or procedure 3 when replacing board.
Procedure 1
Save the EVR data of the machine in which a board is going to be replaced.  Download the saved data after a
board is replaced.
Remove the EEPROM and install it.
(Former board)
(New board)
Procedure 2
Remove the EEPROM from the board of the machine that is going to be repaired.  Install the removed
EEPROM to the replaced board.
Procedure 3
When the data cannot be saved due to defective EEPROM, or when the EEPROM cannot be removed or
installed, save the data from the same model of the same destination, and download it.
After the EVR data is saved and downloaded, check the
respective items of the EVR data.
(Refer to page 6-3 for the items to be checked)
(Machine before starting repair)
(Machine after a board is replaced)
PC
PC
Save the EVR data 
to a personal computer.
Download the saved 
data to a machine.
(Machine to be repaired)
(Machine to be repaired)
(The same model of the same destination)
Save the data.
Download the data.
PC
6-2
HDR-FX1000/FX1000E_ADJ
1-1. Adjusting items when replacing main parts and boards
 Adjusting items when replacing main parts
When replacing main parts, adjust the items indicated by z in the following table.
Note 1:
When replacing the drum assy or the mechanism deck, reset the data of page: 7, address: A8 to AB to “00”. (Refer to “Record of
Use check” of “6-4. SERVICE MODE”)
Note 2:
If the lens is broken, it must be replace with the already adjusted lens.
Table 6-1-1 (1)
Adjustment Section
Adjustment
(3.2 inch wide color LCD unit)
(Backlight)
(Color EVF unit)
(Drum assembly) (Note 1)
(PITCH, YAW sensor)
(Oscillator)
(Camera signal processor)
(Base band signal processor, etc.)
(DV signal processor, etc.)
(Video out AMP)
(Component out AMP)
(REC/PB AMP)
(EVF drive, etc.)
(LCD drive, etc.)
Lens Block (Note 2)
LCD block LCD901
LCD block D901
EVF block LCD902
Mechanism deck (Note 1)
Mechanism deck M901
Mechanism deck MD block
GY-014 board SE8501, 8502
VC-543 board X1401
VC-543 board IC1401
VC-543 board IC1801
VC-543 board IC2601
VC-543 board IC2002
VC-543 board IC2001
MD-141 board IC5201
VF-178 board IC6201
PD-372 board IC6001
Initialization of  
Initialization of A, B, D, 1A, 1B page data
EVR data
Initialization of 8, 9, C, 13, 18, 1C, 1D, 1E page
data
Initialization of camera control page data
Camera
Origin oscillation check
z
PSD sensor adj
Lens adj.
.
z
MR sensor (Focus/Zoom Ring) adj.
z
Coaxial harness connecting check
z
Flange back adj.
Black balance adj.
z
z
z
z
z
z
z
z
z
Auto white balance standard data input
z
z
z
LV standard data input
z
z
z
STD GAIN adj.
z
z
z
Auto white balance adj.
z
z
z
Color reproduction adj.
z
z
z
White defect adj.
z
z
Black defect adj.
z
z
Angular velocity sensor sensitivity adj.
z
EVF
EVF gain adj.
z
LCD
PANEL gain adj.
z
z
V-COM adj.
z
z
Transmissive mode white balance adj.
z
z
z
Mechanism
Tape path adj.
z
z
z
System control
Node 
unique
 ID No. input
Servo, RF
CAP FG duty adj.
z
z
Switching position adj.
z
z
z
SD Error rate check
z
z
z
z
z
Video
S VIDEO OUT Y level adj.
z
z
S VIDEO OUT chroma level adj.
z
z
VIDEO OUT level check
z
z
COMPONENT OUT Y level adj.
z
z
COMPONENT OUT Pr level adj.
z
z
COMPONENT OUT Pb level adj.
z
z
z
z
PRISM device (Inclding CM-097 and CM-104 board and CMOS imager
(IC3001/IC5001))
Replaced part
Block replacement
Mounted part replacement
MAX GAIN adj.
The changed portions from
Ver. 1.0 are shown in blue.
Ver. 1.1  2008.11
6-3
HDR-FX1000/FX1000E_ADJ
Note 3:
IC2402, IC3804 (Flash memo-
ries) on the VC-543 board can-
not be replaced.
 Adjusting items when replacing a board or EEPROM
When replacing a board or EEPROM, adjust the items indicated by z in the following table.
Table 6-1-1 (2)
Adjustment Section
Adjustment
(COMPLETE)
(COMPLETE)
(COMPLETE)
(COMPLETE)
(COMPLETE)
GY-014 board
VC-543 board
MD-141 board
VF-178 board
PD-372 board
(EEPROM)
VC-543 board IC3805
Supporting
Initialization of  
Initialization of A, B, D, 1A, 1B page data
z
EVR data
Initialization of 8, 9, C, 13, 18, 1C, 1D, 1E page
data
z
Initialization of camera control page data
z
Camera
Origin oscillation check
z
PSD sensor adj.
Lens adj.
z
MR sensor (Focus/Zoom Ring) adj.
z
z
z
z
z
z
Coaxial harness connecting check
z
z
Flange back adj.
Black balance adj.
z
z
Auto white balance standard data input
z
z
LV standard data input
z
z
STD GAIN adj.
MAX GAIN adj.
z
z
Auto white balance adj.
z
z
Color reproduction adj.
z
z
White defect adj.
z
z
Black defect adj.
z
z
Angular velocity sensor sensitivity adj.
z
z
EVF
EVF gain adj.
z
z
LCD
PANEL gain adj.
z
z
z
V-COM adj.
z
Transmissive mode white balance adj.
z
z
Mechanism
Tape path adj.
System control
Node 
unique
 ID No. input
z
Servo, RF
CAP FG duty adj.
z
z
z
Switching position adj.
z
z
z
SD Error rate check
z
z
z
Video
S VIDEO OUT Y level adj.
z
S VIDEO OUT chroma level adj.
z
VIDEO OUT level check
z
COMPONENT OUT Y level adj.
z
COMPONENT OUT Pr level adj.
z
COMPONENT OUT Pb level adj.
z
z
Replaced part
RadarW
RadarW
RadarW
z
z
The changed portions from
Ver. 1.0 are shown in blue.
Ver. 1.1  2008.11
6-4
HDR-FX1000/FX1000E_ADJ
Fig. 6-1-1 (1)
1-2. List of service tools
 Oscilloscope
 Color monitor
 Regulated power supply
 Digital voltmeter
 Frequency counter
 Audio level meter
 Balanced audio generator
 Calculating machine capable of calculating hexadecimal numbers
J-12
Tracking standard
(XH2-1)
8-967-997-01
J-13
SW/OL standard
(XH2-3)
8-967-997-11
J-14
Audio operation check
for NTSC (XH5-3)
8-967-997-51
for PAL (XH5-3P)
8-967-997-55
J-9
J-8
Small pattern box
PTB-1450
J-6082-557-A
J-4
Color bar chart
For PTB-1450:
J-6082-559-A
J-5
Clear chart
For PTB-1450:
J-6082-560-A
J-6
Siemens star chart
J-6080-875-A
Filter for color 
temperature correction
(C14)
J-6080-058-A
J-10
ND filter 1.0
J-6080-808-A
ND filter 0.4
J-6080-806-A
ND filter 0.1
J-6080-807-A
J-7
Flange back
adjustment jig
J-6082-563-A
J-11
Camera table
J-6082-384-A
J-1
Adjustment remote
commander 
(RM-95)
J-6082-053-B
J-15
System operation check
for NTSC (XH5-5)
8-967-997-61
for PAL (XH5-5P)
8-967-997-66
J-17
J-3
LANC cable
J-6082-442-A
J-2
Adjustment remote
commander
(NEW LANC JIG)
J-6082-565-A
CPC-13 jig
J-6082-443-A
J-16
J-18
Head cleaning liguid
9-919-573-01
AC Adaptor
(AC-L100)
1-479-286-32
Page of 81
Display

Sony HDR-FX1000 / HDR-FX1000E (serv.man3) Service Manual ▷ Download

  • DOWNLOAD Sony HDR-FX1000 / HDR-FX1000E (serv.man3) Service Manual ↓ Size: 1.02 MB | Pages: 81 in PDF or view online for FREE
  • Here you can View online or download the Service Manual for the Sony HDR-FX1000 / HDR-FX1000E (serv.man3) in PDF for free, which will help you to disassemble, recover, fix and repair Sony HDR-FX1000 / HDR-FX1000E (serv.man3) Movie. Information contained in Sony HDR-FX1000 / HDR-FX1000E (serv.man3) Service Manual (repair manual) includes:
  • Disassembly, troubleshooting, maintenance, adjustment, installation and setup instructions.
  • Schematics, Circuit, Wiring and Block diagrams.
  • Printed wiring boards (PWB) and printed circuit boards (PCB).
  • Exploded View and Parts List.