View Sony CCD-TRV118 Service Manual online
• When the machine needs to be repaired, make sure to follow the items of “LCD TYPE CHECK”.
• HELP: Sheet attachment positions and procedures of processing the flexible boards/harnesses are shown.
2 rotary heads
Helical scanning FM system
Audio recording system
Rotary heads, FM system
NTSC color, EIA standards
8 mm video format cassette
SP mode: 2 hours
LP mode: 4 hours
Approx. 5 min.
Electric viewfinder (monochrom)
3 mm (1/6 type) CCD
(Charge Coupled Device)
4-pin mini DIN
75 Ω (ohms), unbalanced
Chrominance signal: 0.286 Vp-p,
75 Ω (ohms), unbalanced
VIDEO: 1 Vp-p, 75 Ω
unbalanced, sync negative
(at output impedance more than
47 kΩ (kilohms))
Output impedance with less than
2.2 kΩ (kilohms)/Monaural
minijack (ø 3.5 mm)
Mini-minijack (ø 2.5 mm), DC 5 V
6.2 cm (2.5 type)
61 600 (280
DC 8.4 V
DC 7.2 V
5.0 Wh (700 mAh)
65 g (2.3 oz)
subject to change without notice.
Effective: Approx. 200 000 pixels
Combined power zoom lens
Filter diameter: 37 mm
(1 7/16 in)
f = 2.5 – 50 mm (1/8 – 2 in.)
1 lx (lux) (F 1.6)
0 lx (lux) (in the NightShot mode)*
7.2 V (rechargeable battery pack)
8.4 V (AC adaptor)
Average power consumption
(when using the battery pack)
During camera recording using
main unit only
including the rechargeable battery
pack NP-FM30, cassette, lens cap
100 – 240 V AC, 50/60 Hz
0.35 – 0.18 A
DC OUT: 8.4 V, 1.5 A in the
excluding power cord
the dark can be shot with
power cord (1)
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
connections. Check the entire board surface for solder splashes
"pinched" or contact high-wattage resistors.
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
of deterioration. Point them out to the customer and
recommend their replacement.
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
• Unleaded solder melts at a temperature about 40
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
heated tip is applied for too long, so be careful!
ordinary solder so use caution not to let solder bridges occur such
as on IC pins, etc.
also be added to ordinary solder.