Sony SDM-S51 Service Manual ▷ View online
SDM-S51(E)
1-3
1-3. INVERTER MOUNT REMOVAL
1
Two screws
(
+
PWH 3
x
4)
3
Two screws
(
+
PWH 3
x
4)
5
Inverter mount
2
Inverter cover
6
CN1
6
CY2
6
CN2
4
Inverter shield
SDM-S51(E)
1-4
1-4. I/F BOARD REMOVAL
1
Three screws
(
+
PWH 3
x
4)
2
I/F cover
3
Three screws
(
+
PWH 3
x
4)
3
Two screws
(
+
PWH 3
x
4)
6
I/F board mount
5
CN302A
5
CN201
5
CN501
4
Two connector screws
SDM-S51(E)
1-5
1-5. TFT PANEL REMOVAL
1
Four screws
(+PVTP 4
x
12)
2
TFT panel
SDM-S51(E)
2-1
SECTION 2
ADJUSTMENTS
2-1. FUNCTIONAL ALIGNMENT (1)
•Procedures of how to go to service mode.
1. Hold “C” and “B”
key power on, SDM-S51 goes into service mode.
2. Press “MENU” key-----ODS display
→
contigulation
→
RGB Reset
→ ΟΚ
→
contigulation
→
Color Temp.
3. Press “-” key to go to second page’s late icon.
4. Press “OK” key-----service menu display.
5. Select one of features.
6. Press “MENU” key to exit OSD.
7. Power OFF then ON again, monitor go to normal mode.
4. Press “OK” key-----service menu display.
5. Select one of features.
6. Press “MENU” key to exit OSD.
7. Power OFF then ON again, monitor go to normal mode.
If you would like to enter service mode again, performing the above procedures cycle.
Note
1. N/A means “Not applied”.
2. This service menu only provides both Configuration & Sync slice functions.
1. N/A means “Not applied”.
2. This service menu only provides both Configuration & Sync slice functions.
This other were used for design engineering. There is no guarantee of using those N/A functions.
PERFORM
1
RGB RESET
(N/A)
INITIAL EE PRM
OK
ANALOG
CONFIGUR ATION
CHIPS
SYNC SLICE
EXIT
(N/A)
2
COLO R TEMP
INITIAL EE PROM
CLEAR ETI TIME
EEPROM TEST
EXIT
9300K
6500K
5000K
EXIT
SUB-BRIGHTNESS
R
G
B
SUB-CONTRAST
R
G
B
EXIT
On
Off
Click on the first or last page to see other SDM-S51 service manuals if exist.