Sony CPD-E430 Service Manual ▷ View online
CPD-E430 (E)
1-6
4
5
7
4
Remove the D board.
D board
5
Remove the Video block assembly.
1
Prepare a connector (10Pin: Black) (1-766-921-11),
cut of the boss on the 10-pin side.
cut of the boss on the 10-pin side.
Adaptor board (XT Mount) is reconstructied to use for this set.
2
Remove the connector (17Pin: Black) (CN9997)
from Adaptor board (XT MOUNT) (A-1391-123-A).
from Adaptor board (XT MOUNT) (A-1391-123-A).
3
Install the connector (10Pin: Black) onto XT Mount.
6
Install the Adaptor board
(XT MOUNT) (A-1391-123-A).
(XT MOUNT) (A-1391-123-A).
7
Lay the Video block assembly.
Video block assembly
Connector (10Pin: Black)
Boss
Connector
(10Pin: Black)
(10Pin: Black)
Adoptor board
(XT mount)
(XT mount)
Video block assembly
8
Install the video block assembly.
9
Put a box which is about 15cm in height
under the D board to fix it.
(Please disconnect the CN 701 first.)
under the D board to fix it.
(Please disconnect the CN 701 first.)
D board
Box
6
1-6. SERVICE POSITION
CPD-E430 (E)
1-7
1-7. PICTURE TUBE REMOVAL
4
Picture tube
1
Anode cap (Refer to 1-8)
2
A board (C block)
3
Neck assembly
CN1
CN
Connector (2p)
GND
CPD-E430 (E)
1-8
3
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning up
the rubber cap and pulling up it in the
direction of the arrow
separated from the anode button, the
anode-cap can be removed by turning up
the rubber cap and pulling up it in the
direction of the arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Don’t scratch the surface of anode-caps with sharp shaped
material!
material!
2
Don’t press the rubber hardly not to damage inside of anode-
caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3
Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or damage the rubber.
The shatter-hook terminal will stick out or damage the rubber.
•
REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in the
direction indicated by the arrow
direction indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow
firmly in the direction indicated by the
arrow
b
.
a
b
c
Anode Button
CPD-E430 (E)
1-9
1-8. HARNESS LOCATION
CN600
CN602
CN601
CN604
CN1102
CN312
CN311
CN313
CN304
CN318
CN319
CN320
CN316
CN315
CN303
CN1
CN
CN1103
CN1400
CN1602
CN701
CN501
CN904
Picture tube
A board
D board
H1 board
AC inlet
Click on the first or last page to see other CPD-E430 service manuals if exist.