Sony DVP-S300 / DVP-S305 / DVP-S315 Service Manual ▷ View online
– 9 –
7-4.
Deformation of Insulator
1) Assemble the spindle base into the base unit.
2) Lock with 4 shoulder screws. (See Fig. 11)
3) Check if 4 insulators deformed. (See Fig. 11)
2) Lock with 4 shoulder screws. (See Fig. 11)
3) Check if 4 insulators deformed. (See Fig. 11)
Fig. 11
7-5.
Note on Mounting FG-43 Board
1) Align two bosses. (See Fig. 12)
2) Fix the board securely with screws (PTPWH2
2) Fix the board securely with screws (PTPWH2
×
5). (The sen-
sor will not function normally if the board floats up.)
Fig. 12
7-2.
Cleaning Spindle Motor Turntable
1) Remove the tray. (Refer to 2-7)
2) Clean the spindle motor turntable if disc antiskid rubber (black)
2) Clean the spindle motor turntable if disc antiskid rubber (black)
is dirty. (See Fig. 9)
Fig. 9
7-3.
Aligning Phase of Cam Gear and
Drive Gear
Drive Gear
1) Align triangle marks when assembling the cam gear and drive
gear. (See Fig. 10)
Fig. 10
Spindle motor
Turntable
Turntable
Four step screws
Two insulators
Two insulators
Insulator
Good
NG
Drive gear
Cam gear
Align triangle marks.
Screw
(PTPWH2
(PTPWH2
×
5)
FG-43 board
Two bosses
– 10 –
7-6.
Note on Mounting TK-47 Board
1) Align two bosses. (See Fig. 13)
2) Align four tabs. (See Fig. 13)
3) Fix the board securely with 3 screws (BV3
2) Align four tabs. (See Fig. 13)
3) Fix the board securely with 3 screws (BV3
×
10). (The sensor
will not function normally if the board floats up.)
Fig. 13
7-7.
Note on connecting OPT Harness
1) The optical pick-up could be destroyed unless the OPT har-
ness is connected normally to the connector. (See Fig. 14)
Fig. 14
TK-47 board
Three screws
(BV3
(BV3
×
10)
Two claws
Boss
Two claws
Boss
OPT harness
Connector
Good
NG
1-1
SECTION 1
GENERAL
DVP-S300/S305/S315
This section is extracted from
DVP-S315 instruction manual.
DVP-S315 instruction manual.
1-2
Click on the first or last page to see other DVP-S300 / DVP-S305 / DVP-S315 service manuals if exist.