Sony SAL500F80 Service Manual ▷ View online
2-3
SAL500F80 (REFLEX 8/500) (500mm F8 Reflex)
2-1-2. HELICOID UNIT
6 G6 Lens
4 G1 Lens Holder
5 G2+G4+G5 Assy
3 G1+G3+G7 Assy
G2 Lens Holder
G2 Stopper
EXPLODED VIEW
OPTICAL AXIS
CHECK/ADJUSTMENT
CHECK/ADJUSTMENT
Note: Always perform the optical axis check/adjustment when the
lens is removed.
lens is removed.
OPTICAL AXIS
CHECK/ADJUSTMENT
CHECK/ADJUSTMENT
HELP13
HELP11
HELP10
HELP12
HELP14
1 Focus Rubber Ring
2 G1 Adjustment
Screw
Screw
G1 Stopper
HELP
SAL500F80 (REFLEX 8/500) (500mm F8 Reflex)
HELP
Note for assembling and grease applying positions are shown.
HELP01
Adhesive bond (B-40): J-6082-614-A
1.
Attach the rear light shield barrel. Apply the adhesive bond (B-40) to the three screws, and then fix the rear light shield barrel with
these screws as shown in the figure.
2.
Attach the ground spring to the rear light shield barrel.
3.
Attach the signal PC board, and fix it with the two screws as shown in the figure.
Note:
Be careful not to tighten the two screws too much.
Apply the Adhesive Bond
(B-40) (Three areas)
(B-40) (Three areas)
Signal PC Board
Screws
Ground spring
Rear Light Shield Barrel
HELP
SAL500F80 (REFLEX 8/500) (500mm F8 Reflex)
HELP02
Adhesive bond (LOCTITE 460)(Note)
Note:
Use the adhesive bond (LOCTITE 460) or an equivalent article.
Do not use what becomes white after drying like quick-drying glue.
Apply the adhesive bond (LOCTITE 460) to the instruction portion of the light shield plate as shown in the figure, and affix it to the rear
light shield barrel.
Rear Light Shield Barrel
Light Shield Plate
Apply the Adhesive Bond (LOCTITE 460)
HELP
SAL500F80 (REFLEX 8/500) (500mm F8 Reflex)
HELP03
Anti-diffusion agent (A-20): J-6082-611-A
Grease (G-85):
J-6082-626-A
Adhesive bond (LOCTITE 460)(Note)
Note:
Use the adhesive bond (LOCTITE 460) or an equivalent article.
Do not use what becomes white after drying like quick-drying glue.
1.
Apply the adhesive bond (LOCTITE 460) to the instruction portion of the stopper screw as shown in the figure
2.
Apply the anti-diffusion agent (A-20) to the instruction portion of the mount block as shown in the figure.
3.
Apply the grease (G-85) under the three claws of the mount block as shown in the figure.
4.
Attach the mount block with the four screws as shown in the figure.
Apply the Grease (G-85) (Under three claws)
Apply the Grease (G-85)
Apply the Anti-Diffusion Agent (A-20)
Apply the Anti-Diffusion Agent (A-20) (All circumference of back side)
Apply the Adhesive Bond
(LOCTITE 460)
(LOCTITE 460)
Click on the first or last page to see other SAL500F80 service manuals if exist.