Sony SAL24105 Service Manual ▷ View online
HELP
SAL24105 (3.5-4.5/24-105) (24-105mm F3.5-4.5)
HELP22
Atttach the securely the torque ring spring A or torque ring spring B to the position shown in figure.
HELP23
Grease (G-115): J-6082-627-A
1.
Apply the grease (G-115) to the indicated portion (entire circumference) of focus ring B.
2.
Insert the focus ring B, aligning its projection with the cut portion of focus ring.
Torque Ring
Torque Ring Spring
Fixed Holding Tube Block
Focus Ring B
Apply the grease (G-115)
Focus Ring B
Focus Ring
Torque Ring
Cut Portion
Projection
Ver 1.3 2007.07
HELP
SAL24105 (3.5-4.5/24-105) (24-105mm F3.5-4.5)
HELP24
Anti-diffusion agent (A-20): J-6082-611-A
Grease (G-115):
J-6082-627-A
1.
Apply the anti-diffusion agent (A-20) to the indicated portion of torque ring.
2.
Apply the grease (G-115) to the indicated portion (entire circumference) and straight key of torque ring.
3.
After applying the grease (G-115) and anti-diffusion agent (A-20), clean the area indicated by the arrow.
HELP25
Adhesive bond (B-10): J-6082-612-A
After adjusting the focus brush, tighten two screws to fix the focus brush, and apply the adhesive bond (B-10) to the indicated portion.
Note:
For focus brush adjustment, refer to P.4-38.
Torque Ring
Apply the grease (G-115)
Apply the grease (G-115)
Cleaning area
indicated by
the arrow
indicated by
the arrow
Apply the anti-diffusion agent (A-20)
to the entire circumference
to the entire circumference
Straight Groove
Focus Brush
Fixed Holding Tube Block
Apply the adhesive bond
(B-10)
(B-10)
HELP
SAL24105 (3.5-4.5/24-105) (24-105mm F3.5-4.5)
HELP26
Adhesive bond (B-40): J-6082-614-A
1.
Set the zoom to “Tele end”. Insert the focus operating lever in the forked portion of focus joint tube and attach it to the 2nd lens
block.
2.
Apply the adhesive bond to the tips of two screws and tighten them as shown in figure.
Focus Cam Tube Block
Apply the adhesive bond (B-40)
2 group Lens Block
Focus Joint Tube
Focus Operating Lever
Forked Portion
HELP
SAL24105 (3.5-4.5/24-105) (24-105mm F3.5-4.5)
HELP27
Adhesive bond (B-10): J-6082-612-A
1.
Rotate the focus joint tube so that “half of 1 tooth” can be hide out from the support of gear (A, B) block.
2.
Insert the focus ring, aligning its projection (The chip of focus inner gear should locate at the gear (A, B) block) with the cut portion
of fixed holding tube block
3.
Rotate clockwise the focus ring so that distance tube gear engages with the gear block (A, B) lock.
Gear (A, B) Block
EDGE of gear (A, B) block
“1 tooth”
Focus Joint Tube
“1 tooth”
Cut Portion
Cut Portion
Projection
Projection
Focus Ring
Fixed Holding Tube Block
Chip of Focus Inner Gear
Focus Ring
Click on the first or last page to see other SAL24105 service manuals if exist.