DOWNLOAD Sony SAL135F18Z Service Manual ↓ Size: 2.41 MB | Pages: 79 in PDF or view online for FREE

2-4

SAL135F18Z (Sonnar 1.8/135 ZA) (Sonnar T

 135mm F1.8 ZA)

A

A

B

B

C

C

1 1 Lens Block

2 Ornamental 2 Sheet

4 2 Lens Blcok

5 Iris Block

6 3 Lens Block

7 4 Lens Block

8 Scale Focus Sheet

3 Zoom Brush

In case the installing of 1 lens block :
Install the 1 lens block placed with same position of removing it to the length grove barrel assy.
* When removing the 1 lens block, put the marks of both the 1 lens block and length grove
   barrel assy.

Note: 

SAL135F18Z (Sonnar 1.8/135 ZA) (Sonnar T

 135mm F1.8 ZA)

Note for assembling and grease applying positions are shown.

Adhesive bond (B-10):

J-6082-612-A

Filter screw frame removing tool: J-6082-649-A

1.

Apply the adhesive bond (B-10) in 10mm width to the location shown in figure of draw ring assy.

2.

Aligning the inner cut portions at three locations with the guide pins, install the screw filter frame assy with the print of [1.8/135]

placed at the distance scale window side.

Draw Ring Assy

Apply the adhesive bond (B-10) 
(width 10mm)

Apply the adhesive bond (B-10) 
(width 10mm)

Screw Filter Frame Assy

Inner Cut Portions

Guide Pin

Guide Pins

Distance Scale Window

Inner Cut Portions

SAL135F18Z (Sonnar 1.8/135 ZA) (Sonnar T

 135mm F1.8 ZA)

3.

Push the filter screw frame removing tool to the draw ring assy and rotate it counterclockwise as far as it goes and stops.

Adhesive bond (B-40): J-6082-614-A

1.

Install the draw ring assy.

2.

Apply the adhesive bond (B-40) to the tip of three guide pins and tighten them.

Guide Pins
(Apply the adhesive bond (B-40))

Guide Pins
(Apply the adhesive bond (B-40))

Draw Ring Assy

Filter screw frame removing tool

The changed portions from
Ver. 1.3 are shown in blue.

SAL135F18Z (Sonnar 1.8/135 ZA) (Sonnar T

 135mm F1.8 ZA)

Screws
(Apply the adhesive bond (B-10))

Screw
(Apply the adhesive bond (B-40))

Screws
(Apply the adhesive bond (B-40))

Preset Ring

Light Shield Ring Block

Adhesive bond (B-10): J-6082-612-A

1.

Install the focus ring and tighten three screws to fix it.

2.

Apply the adhesive bond (B-10) to the heads of screws.

Adhesive bond (B-40): J-6082-614-A

1.

Install the rear light shiled ring block, apply the adhesive bond (B-40) to the screws, and tighten three screws.

 Be careful not to drop screws in the lens.

2.

Confirm that the preset ring moves smoothly.