DOWNLOAD Sony DSLR-A900 Service Manual ↓ Size: 19.73 MB | Pages: 112 in PDF or view online for FREE

1-3

DSLR-A900_L2

Make sure to confirm below before replacing the AS Slider B Assy.

(1) Remove the CV Rear Cover Assy, and temporally mount the AS Slider Unit.
(2) Set the AS Slider Unit upwards as shown in figure, and put it on a stable place.

Note: The shape is different from the picture depending on a model.

(3) Select “Slider Unit Check” of the adjustment software, and then confirm the movement to the directions of Pitch and Yaw, and if an error

occurs, replace it with the component part corresponding to the movement.

1-4

DSLR-A900_L2

Make sure to confirm below after replacing the AS Slider B Assy.

(1) Remove the CV Rear Cover Assy, temporally mount the AS Slider Unit mounted with the Imager Sensor, and then set up the camera body

and hold the AS Slider Unit as shown in figure.

Note: The shape is different from the picture depending on a model.

(2) Select “Slider Unit Check” of the adjustment software, and then confirm if the result is OK.
(3) Select “Tebure Revise Adj.” of the adjustment software, and then confirm if the result is OK.
(4) Mount the AS Slider Unit to the camera.

1-5

DSLR-A900_L2

(4) Pull out the Plate CAP.

(5) Remove the Spring Torsion (CAP) from the Plate CAP.

(6) Pull out the Plate CAP.

(7) Remove the Slider A Assy while releasing the hooks.

(1) Remove the spring.

(2) Remove the solder on the enamel wires at two places.

(3) Remove the Spring Torsion (CAP) from the Plate CAP.

Spring

Solder

Plate Cap

Spring Torsion (CAP)

Plate Cap

Spring
Torsion (CAP)

Plate Cap

Plate Cap

Slider A  Assy

Hook

Hook

1-6

DSLR-A900_L2

(8) Remove the two screws to detach the Plate Angle Adjustment

and the Plate Retainer.

(9) Remove the Slider B Assy and the Bearing Balls while releasing

the hooks.
Note: Pay attention to prevent the Bearing Balls from falling.

Plate Angle
Adjustment

Plate
Retainer

Slider B Assy

Bearing Balls

Bearing Ball

Hook

Hook

The assembly procedure is the reverse of the removal procedure.
Apply grease to the portions indicated below.
Note: After applying grease, attach the Ball Bearings.

G

 

G-15 and  G G-116

Slider B Assy

Slider B Assy

Slider B Assy

Bearing Balls
G

 

G-15

Bearing Balls
G

 

G-15