DOWNLOAD Sony DSC-WX350 (serv.man2) Service Manual ↓ Size: 6.47 MB | Pages: 42 in PDF or view online for FREE

DSC-WX350

4-10

Removal
1.  Remove the two screws and remove the Z Motor Assy.

 

Screws

Z Motor Assy

2.  Disengage the two claws and remove the FG Plate Spring.
3.  Remove the two sensors.
4.  Remove solders at two locations to detach the Z Motor Assy.

 

.

Z Motor Assy

Solders

Z Motor Assy

FG Plate
Spring

Sensor

Sensor

Claws

Installation
1.  Solder the Z Motor Assy at two locations.
2.  Install the two Sensors.
3.  Attach the FG Plate Spring.

 

Z Motor Assy

Solders

Z Motor Assy

FG Plate
Spring

Sensor

Sensor

Claws

4.  Install the Z Motor Assy and install the two screws.

 

Screws

Z Motor Assy

DSC-WX350

4-11

Removal
1.  Remove the five screws.

 

Screws

Screws

2.  Remove the Z Motor Assy, peel off the adhesive part of the Main Flexible Assy, and then disconnect the Connector.
3.  Remove the Naruto Gear.

 

Main Flexible Assy

Z Motor Assy

Naruto Gear

Connector

4.  Remove the Rear Lens Assy.

 

Rear Lens Assy

DSC-WX350

4-12

5.  Push the Linear Cam Barrel to protrude it to the object side so that the Drive Gear Barrel can be held.
6.  Pull down the Drive Gear Barrel to the maximum.
7.  Turn the Drive Gear Barrel clockwise to the maximum.

 

Drive Gear Barrel

Object side

Linear Cam Barrel

8.  Remove the flexible board from the hole of the Fixed Barrel.
9.  Set the lens unit in the retracted state.

 

Hole of the
Fixed Barrel

Flexible Board

10. Detach the Fixed Barrel while further turning the gear counterclockwise with a flat-blade screwdriver or a similar flat tool.

 

Gear

Fixed Barrel

Core unit_1

11.  Detach the Core unit_2 from the Linear Cam Barrel and the Drive Gear Barrel.

 

Linear Cam Barrel,
Drive Gear Barrel

Core unit_2

DSC-WX350

4-13

12. Turn the Linear Cam Barrel to set it at position A, and then detach the Linear Cam Barrel from the Drive Gear Barrel.

 

Linear Cam Barrel

Drive Gear Barrel

Linear Cam Barrel

Rounded cutout

Edge of gear

A

13. Turn the rear edge of Core unit_2 counterclockwise to set it in the state shown below.
14. Release the three claws beside the bosses with tweezers or the like to detach the 1st Cam Barrel Assy,1st Group Assy.

Note: When releasing the claws, push out the 1st Cam Barrel Assy with tweezers and lift the claws.

 

1

2

1

2

Bosses

Claws

Claw

Core unit_3

Hook

Hooks

Claw

Hook

Rear edge of
Core unit_2

1st Cam Barrel Assy,
1st Group Assy

Boss

Push out the 1st Cam
Barrel Assy.

Tweezers

Lift the claw.

Tweezers

15. Turn the 1st Group Assy clockwise to detach it.

 

1st Cam Barrel Assy

1st Group Assy

1st Group Assy