Sony DSC-N1 (serv.man2) Service Manual ▷ View online
2-15
DSC-N1_L2
2. DISASSEMBLY
2. DISASSEMBLY
2-4-5. INSTALL NEW F PLATE SPRING
Hold the reset P1 sensor with the F plate spring to secure.
1
Hook two claws of the F plate spring on the zoom gear block.
2
Engage two claws of the zoom gear block and F plate spring.
2-4-4. INSTALL NEW 3 GROUP SPRING
Hook the 3 group spring on the front lens block by using the tweezers, etc.
Tweezers etc.
Hook
3 group spring
(Non-replaceable part. Beware of damage.)
(Non-replaceable part. Beware of damage.)
F plate spring
P1 reset sensor
1
2
2-16E
DSC-N1_L2
2. DISASSEMBLY
2. DISASSEMBLY
2-4-6. INSTALL NEW S PLATE SPRING
Boss
Boss
Flexible cable
S plate spring
1
2
Check that the flexible cable is secured with four
bosses of the front lens block as shown above.
bosses of the front lens block as shown above.
1
Insert the claw of the S plate spring into a hole in the front lens
block.
block.
2
Engage the S plate spring with the claw of the front lens block.
2-4-7. CHECK THE OPERATION
Confirm the operation after installing the lens in the set.
1.
1.
Power ON/OFF
2.
Expansion and contraction confirming of lens and opening and shutting confirmation of barrier.
Confirm there are neither dirt nor wounds in the surface of the ornamental ring (A) and lens if there is no problem in operation.
Wipe off when dirty.
Confirm there are neither dirt nor wounds in the surface of the ornamental ring (A) and lens if there is no problem in operation.
Wipe off when dirty.
3.
Confirm the operation with Wide/Tele.s
Note:
Do not be of caught etc.
Do not allophone.
Do not allophone.
HELP
DSC-N1_L2
HELP
Sheet attachment positions and procedures of processing the flexible boards/harnesses are shown.
1
Pass the BT discharge
spring through a hole
in the holder (spring).
spring through a hole
in the holder (spring).
2
Route the BT discharge spring
in front of the holder (spring)
and hook it onto the plate
as shown below.
in front of the holder (spring)
and hook it onto the plate
as shown below.
BT discharge
spring
spring
holder
(spring)
(spring)
S005
SW-460 flexible board
Cabinet (rear) assembly
Mode knob
SW-460 flexible board
Claw
(Retainer plate (LCD))
(Retainer plate (LCD))
Claw
(Retainer
plate (LCD))
(Retainer
plate (LCD))
HELP
DSC-N1_L2
SP-046 flexible board
RL-062 flexible board
Claw
Adhesive sheet
(including SP
flexible board)
(including SP
flexible board)
Cabinet (rear) section
Cabinet (senter) section
Click on the first or last page to see other DSC-N1 (serv.man2) service manuals if exist.