Sony DSC-HX60 / DSC-HX60V Service Manual ▷ View online
DSC-HX60/HX60V
4-4
4-3-2. Main Section
• Disassembly order
No.
Part
Item
Note
1
Main Frame
#243 x 3
Remove the Antenna Holder. (Claw x 2)
2
SY-1032 Board, SW-
1017 Flexible Board
1017 Flexible Board
#243 x 1
Connector x 6
Connector x 6
Refer to “Notes on Assembling the SY-1032 Board” when assembling. (page 4-6)
3
Lens Block Section
4
Charging Capacitor
Discharging of the Charging Capacitor.
5
BTH Block Section
#243 x 1
Connector x 1
Connector x 1
6
Upper Block Section
#243 x 2
Refer to “Notes on Assembling the Upper Block” when assembling. (page 4-7)
7
Multi Lid
8
Cabinet Front
A
B
C
A
B
D
C
D
Be sure disconnect the this connector,
after removing the BTH Block from the main unit.
after removing the BTH Block from the main unit.
BT-2010 Flexible Board
Note:
高電圧の警告
Short-circuit the terminals of the flash capacitor
with a Short Jig for approximately 10 seconds.
Refer to the Service Note for a Short Jig.
with a Short Jig for approximately 10 seconds.
Refer to the Service Note for a Short Jig.
Note: Warning of high voltage
ストロボ用充電コンデンサの端子間に
ショート治具を接続し,約10秒間,放電
を行ってください。
ショート治具についてはサービスノート
を参照してください。
ショート治具を接続し,約10秒間,放電
を行ってください。
ショート治具についてはサービスノート
を参照してください。
Short Jig
ショート治具
The charging capacitor for the flash
ストロボ用充電コンデンサ
ストロボ用充電コンデンサ
2
8
7
1
3
Lens Block Section
5
BTH Block Section
6
Upper Block Section
(See page 4-5)
4
Claw
Claw
Antenna
Holder
Holder
Be careful not to break the FPC plate,
when disassembling and assembling.
when disassembling and assembling.
#243 (5)
#243 (1)
#243 (2)
#243 (6)
Hold the Lens Block at the
center of both sides.
center of both sides.
Do not hold the following part.
Hold here.
PRECAUTIONS WHEN HOLDING THE LENS BLOCK
Lens Barrier
Very weak
Focus Unit
Very weak
Zoom Motor
Very weak
Focus Lens
Very weak
Connector
#243: M1.4 X 3.5
(Black)
4-412-769-01
4-412-769-01
3.5
1.4
DSC-HX60/HX60V
4-5
4-3-3. Upper Block Section
• Disassembly order
No.
Part
Item
Note
1
Shoe Frame
#28 x 2
#140 x 4
#140 x 4
Peel the Insulating sheet.
2
Control Switch Block
#28 x 2
Connector x 1
Connector x 1
3
GPS Plate
4
RL-1011 Board
Plate (Rotary Base)
RL-1012 Flexible Board
Plate (Rotary Base)
RL-1012 Flexible Board
Refer to “Notes on Assembling the RL -1011 Board” when assembling. (Page 4-6)
5
ST Cover
#284 x 2
Push the Flash pop-up button.
6
ST Block Assy
#28 x 1
7
Loudspeaker (1.0cm)
Solder x 2
8
SH-1006 Board
Remove the Mic Holder from the Cabinet Upper, then remove the SH-1006 board.
9
Cabinet Upper
#28: M1.4 X 4.0 (Tapping)
(Silver)
3-348-998-61
3-348-998-61
1.4
4.0
#140: M
1.7
X 2.0
(Black
)
2-635-562-01
2.0
1.7
#284: M1.4 X 3.0 (Tapping)
(Black)
4-433-882-21
4-433-882-21
3.0
1.4
#140
#28
#28
#28
#28
#284
RL-1012
Flexible Board
Flexible Board
Insulating sheet
Plate
(Rotary Base)
(Rotary Base)
MIC Holder
Flash pop-up
Button
Button
#284
1
2
3
4
5
6
8
7
9
Do not touch this part.
(DSC-HX60V only)
(DSC-HX60V only)
Solders
DSC-HX60/HX60V
4-6
4-3-4. Complementary Information
(1) Notes on Assembling the Button (Center) and the
Button (KURUPON)
Button (Center)
Button (KURUPON)
Claws
Claws
(2) Notes on Assembling the LCD unit
After the LCD unit has been installed, make sure that the Flexible
Board of the LCD unit is arranged within the SY-1032 Board area.
Board of the LCD unit is arranged within the SY-1032 Board area.
SY-1032 Board
Flexible Board
of the LCD unit
of the LCD unit
(3) Notes on Assembling the SY-1032 Board
Be sure install the SY-1032 Board to main unit, after install the
SW-1017 Flexible Board to the SY-1032 Board.
SW-1017 Flexible Board to the SY-1032 Board.
SW-1017 Flexible Board
SY-1032 Board
1
2
(4) Notes on Assembling the RL-1011 Board
Rotary plate
RL-1011 Board
Cabinet (Upper) Assy
Marking
(Adjust the position)
Adjust the position
DSC-HX60/HX60V
4-7
(5) The Method of attachment of the BT-2010 Flexible Board
(1) Install the Terminal Battery Board to the BTH Assy.
Terminal Battery Board
BTH Assy
(2) Connect the BT-2010 Flexible Board to the Terminal Battery
Board.
BT-2010 Flexible Board
Terminal Battery Board
BTH Assy
(3) Set the Lithium Rechargeable Battery.
Lithium Rechargeable
Battery
Battery
(4) Set the claws and bosses.
Bosses
Claws
Claws
(6) Notes on Assembling the Upper Block
Route the speaker harnesses.
Cabinet (Front)
Speaker
Upper Block
Click on the first or last page to see other DSC-HX60 / DSC-HX60V service manuals if exist.