View Sony DSC-H5 (serv.man2) Service Manual online
The components identified by
mark 0 or dotted line with mark
0 are critical for safety.
Replace only with part number
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
pièce portant le numéro spécifié.
Troubleshooting of DSC-H5 (2-673-176-11 (1)).
CCD, Primary color filter
432 mm when converted to a
35 mm still camera)
F2.8 – 3.7
priority, Manual exposure,
Scene Selection (7 modes)
Flash, One push
JPEG compliant, DPOF
Movies: MPEG1 compliant
approx. 0.3 m to 9.0 m (11 7/
8 inches to 29 feet 6 3/8 inches)
(W)/approx. 0.9 m to 6.8 m
(35 1/2 inches to 22 feet 3 3/
4 inches) (T)
Video: 1 Vp-p, 75
Audio: 327 mV (at a 47 k
Output impedance 2.2 k
Nickel-Metal Hydride batteries
(2), 2.4 V
batteries (2), 3 V
Primary Battery (2), 3 V
(including two batterries,
shoulder strap, adaptor ring,
lens hood, lens cap, etc.)
connections. Check the entire board surface for solder splashes
"pinched" or contact high-wattage resistors.
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
of deterioration. Point them out to the customer and
recommend their replacement.
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
• Unleaded solder melts at a temperature about 40
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
heated tip is applied for too long, so be careful!
ordinary solder so use caution not to let solder bridges occur such
as on IC pins, etc.
also be added to ordinary solder.
MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
INTERNAL MEMORY ·················································· 1-2
BOARD ··········································································· 1-3
• C: ss: ss
by customer, are displayed.
by engineer, are displayed.
of flash unit. (Note)