Sony DSC-F505 Service Manual ▷ View online
– 5 –
SERVICE NOTE
[Discharging of the FLASH unit’s charging capacitor]
The charging capacitor of the FLASH unit is charged up to the
maximum 300 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the DSC-F505 is simply turned off. Therefore, the
remaining voltage must be discharged as described below.
maximum 300 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the DSC-F505 is simply turned off. Therefore, the
remaining voltage must be discharged as described below.
Preparing the Short Jig
To preparing the short jig. a small clip is attached to each end of a
resistor of 1k
resistor of 1k
Ω
/1W (1-215-869-11)
Wrap insulating tape fully around the leads of the resistor to prevent
electrical shock.
electrical shock.
Discharging the Capacitor
Short circuits between the positive and the negative terminals of
charged capacitor with the short jig about 10 seconds.
charged capacitor with the short jig about 10 seconds.
1k
Ω
/1W
Wrap insulating tape.
Short jig
Capacitor
Flash unit (MC)
– 6 –
Note :
The error code is cleared if the battery is removed, except defective
flash, unit.
flash, unit.
*1 : The error display is given in two ways.
*2 : When the flash charging failed, Page:D, Address:C7, Data:04 are
*2 : When the flash charging failed, Page:D, Address:C7, Data:04 are
written.
After repair, be sure to write Page:D, Address:C7, Data:00.
After repair, be sure to write Page:D, Address:C7, Data:00.
Self-diagnosis display
• C:
ππ: ππ
You can reverse the camera
malfunction yourself. (However,
contact your Sony dealer or local
authorized Sony service facility
when you cannot recover from the
camera malfunction.)
malfunction yourself. (However,
contact your Sony dealer or local
authorized Sony service facility
when you cannot recover from the
camera malfunction.)
• E:
ππ: ππ
Contact your Sony dealer or local
authorized Sony service facility.
authorized Sony service facility.
[Description on Self-diagnosis Display]
Display Code
C:04:
ππ
C:32:
ππ
C:13:
ππ
E:61:
ππ
E:91:
ππ
Countermeasure
Use a NP-FS11/F10 battery pack.
Turn the power off and on again.
Format the “Memory stick”.
Insert a new “Memory Stick”.
Checking of lens drive circuit.
Cause
You are using a basttery pack that is not an
“InfoLITHIUM” battery pack.
“InfoLITHIUM” battery pack.
Trouble with hardware.
Unformatted memory stick is inserted.
Memory stick is broken.
When failed in the focus and zoom
initialization.
initialization.
Abnormality when flash is being
charged.
charged.
Checking of flash unit or replacement
of flash unit.
of flash unit.
Caution Display During Error
for “InfoLITHIUM” BATTERY
ONLY
ONLY
SYSTEM ERROR
FORMAT ERROR
MEMORY STICK ERROR
—
*1
*2
1-1
DSC-F505
SECTION 1
GENERAL
This section is extracted from
instruction manual.
instruction manual.
1-2
Click on the first or last page to see other DSC-F505 service manuals if exist.