Sony XR-C543SP Service Manual ▷ View online
– 13 –
LEVER (PINCH SELECTION)
HEAD PLATE ASS’Y
5
step screw (HP)
5
step screw (HP)
2
Fit shaft in groove.
ATS lever
1
Fit in groove.
3
Press the ATS lever.
4
Position the head plate sub
ass’y as shown in the figure.
ass’y as shown in the figure.
groove
1
Align.
2
lever (pich selection)
– 14 –
LEVER (PINCH) ASS’Y
HOUSING
2
Install the hanger on to
two claws of the housing.
two claws of the housing.
1
Install the catch to the hanger.
7
Holder the hanger by bending the claw.
A
part
B
part
C
part
D
part
8
Holder the hanger by
bending the claw.
bending the claw.
3
Put the housing
under
under
A
part.
4
Fit claws on
B
part.
6
Fit projections on
D
part.
5
Fit projections on
C
part.
hanger
1
Fit shaft of the lever (Pinch) ass’y
in hole on the chassis (M) ass’y and
install the lever (pinch) ass’y.
in hole on the chassis (M) ass’y and
install the lever (pinch) ass’y.
2
two polyethylene washers
shaft
shaft
B
C
C
B
shaft
A
3
Install the spring (pinch press) to
shaft
shaft
A
.
Set the ends of spring to
B
and
C
.
– 15 –
1
Fit the lever (LDG-A)
on shaft
on shaft
A
–
C
and install it.
shaft
A
shaft
B
shaft
C
3
two type-E stop ring 2.0
2
Fit the lever (LDG-B)
on shafts
on shafts
A
and
B
and
install.
shaft
A
shaft
B
LEVER (LDG-A) / (LDG-B)
ARM (SUCTION)
2
Move the arm (suction) in the arrow
direction and fit on projection.
direction and fit on projection.
1
Fit the arm (suction) on the shaft.
projection
– 16 –
GEAR (LDG-FT)
2
guide (C)
1
three claws
4
Align hole in the gear (LDG-D) with
¢
mark on the lever (LDG-A).
hole
gear (LDG-D)
gear (LDG-A)
3
Move the lever (LDG-B)
in the arrow direction.
in the arrow direction.
1
gear (LDG-A)
2
tension spring (lever LDG)
5
gear (LDG-FT)
6
polyethylene washer
GUIDE (C)
gear (LDG-FB)
Click on the first or last page to see other XR-C543SP service manuals if exist.