Sony XM-7547 Service Manual ▷ View online
3
SECTION 1
SERVICE NOTE
Clearing the Protector During Repairs
• OVER CURRENT : Detects overcurrent during output.
• OFF SET : Detects DC offset at the speaker terminal.
• OFF SET : Detects DC offset at the speaker terminal.
1. Clearing the OVER CURRENT protector
1 When the position of the MODE switch (S801/power board)
is set to HI-VOLTAGE :
Cut the jumper wire JW535 of the amplifier board.
Cut the jumper wire JW535 of the amplifier board.
2 When the position of the MODE switch (S801/power board)
is set to HI-CURRENT :
Cut the jumper wire JW690 of the amplifier board.
Cut the jumper wire JW690 of the amplifier board.
2. Clearing the OFF SET protector
• Cut the jumper wire JW502 of the amplifier board.
3. TEST TONE Function
1 Press the TEST TONE button (S851/amplifier board) with the
power ON. The amplifier is normal if sound is produced from
the speaker.
the speaker.
2 If no sound
: Problem causer by incorrect connecttion of the power supply
: Problem causer by incorrect connecttion of the power supply
system or sperker system.
: The signals input by the RCA cable before the amplifier system
are abnormal.
Adjustment Location:
S851
TEST
TONE
TONE
JW535
JW690
JW502
- POWER BOARD - (Component side)
- AMPLIFIER BOARD - (Component side)
S801
MODE
4
SECTION 2
GENERAL
This section is extracted from
instruction manual.
instruction manual.
5
6