DOWNLOAD Sony CDX-S2210 / CDX-S2210S / CDX-S2210X / CDX-S2250EE / CDX-SW330 Service Manual ↓ Size: 9.61 MB | Pages: 76 in PDF or view online for FREE

Model
CDX-S2210 CDX-S2210S CDX-S2210X CDX-S2250EE CDX-SW330
Pages
76
Size
9.61 MB
Type
PDF
Document
Service Manual
Brand
Device
Car Audio
File
cdx-s2210-cdx-s2210s-cdx-s2210x-cdx-s2250ee-cdx-sw.pdf
Date

Sony CDX-S2210 / CDX-S2210S / CDX-S2210X / CDX-S2250EE / CDX-SW330 Service Manual ▷ View online

1
Ver. 1.
3
  2005.
 11
Model Name Using Similar Mechanism
NEW
CD Drive Mechanism Type
MG-611TA-186//K
Optical Pick-up Name
KSS1000E
SERVICE MANUAL
US Model
CDX-S2210/SW330
Canadian Model
CDX-S2210
E Model
CDX-S2210S/S2210X
East European Model
CDX-S2250EE
CDX-S2210/S2210S/S2210X/
S2250EE/SW330
AUDIO POWER SPECIFICATIONS (US Model)
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23.2 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more
than 5% total harmonic distortion.
CD player section
Signal-to-noise ratio
120 dB
Frequency response
10 – 20,000 Hz
Wow and flutter
Below measurable limit
Tuner section
FM
Tuning range
US, Canadian Model:
87.5 – 107.9 MHz
E model:
FM tuning interval:
50 kHz/200 kHz
switchable
87.5 – 108 MHz (at 50 kHz step)
87.5 – 107.9 MHz (at 200 kHz step)
East European Model:
FM1/FM2: 87.5 – 108.0 MHz (at 50 kHz step)
FM3: 65 – 74 MHz (at 30 kHz step)
Antenna terminal
External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Usable sensitivity
9 dBf
Selectivity
75 dB at 400 kHz
Signal-to-noise ratio
67 dB (stereo),
69 dB (mono)
Harmonic distortion at 1 kHz
0.5% (stereo),
0.3% (mono)
Separation
35 dB at 1 kHz
Frequency response
30 – 15,000 Hz
SPECIFICATIONS
AM
Tuning range
US, Canadian Model:
530 – 1,710 kHz
E Model:
AM tuning interval:
9 kHz/10 kHz switchable
531 – 1,602 kHz (at 9 kHz step)
530 – 1,710 kHz (at 10 kHz step)
East European Model:
531 – 1,602 kHz
Antenna terminal
External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity
30 
µV
Power amplifier section
Outputs
Speaker outputs
(sure seal connectors)
Speaker impedance
4 – 8 ohms
Maximum power output Except East European model:
52 W 
× 4 (at 4 ohms)
East European model:
50 W 
× 4 (at 4 ohms)
General
Outputs
Audio outputs terminal (sub/rear switchable)
Power antenna relay control terminal
Power amplifier control terminal
Inputs
Antenna input terminal
Remote controller input terminal (CDX-S2210C only)
• The tuner and CD sections have no adjustments.
Sony Corporation
eVehicle 
Division
Published by Sony Engineering Corporation
9-879-323-0
4
2005
K
04-1
© 2005.
 11
– Continued on next page –
FM/AM COMPACT DISC PLAYER
Photo: CDX-S2250EE
2
CDX-S2210/S2210S/S2210X/S2250EE/SW330
If the optical pick-up block is defective, please replace the whole
optical pick-up block.
Never turn the semi-fixed resistor located at the side of optical
pick-up block.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
SAFETY-RELATED  COMPONENT  WARNING!!
COMPONENTS  IDENTIFIED  BY  MARK  
0
  OR  DOTTED  LINE
WITH  MARK  
0
  ON  THE  SCHEMATIC  DIAGRAMS  AND  IN
THE  PARTS  LIST  ARE  CRITICAL  TO  SAFE  OPERATION.
REPLACE  THESE  COMPONENTS  WITH  SONY  PARTS  WHOSE
PART  NUMBERS  APPEAR  AS  SHOWN  IN  THIS  MANUAL  OR
IN  SUPPLEMENTS  PUBLISHED  BY  SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
 À LA SÉCURITÉ!!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 
0
 SUR LES
DIAGRAMMES SCHÉMATIQUES ET LA LISTE  DES PIÈCES
SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT.
NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES
SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL
OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
Tone controls
Low: 
±10 dB at 60 Hz (XPLOD)
Mid: 
±10 dB at 1 kHz (XPLOD)
High: 
±10 dB at 10 kHz (XPLOD)
Power requirements
12 V DC car battery
(negative ground)
Dimensions
Approx. 178 
× 50 × 178 mm
(7 
1/8
 
× 2 × 7 
1/8
 in.) (w/h/d)
Mounting dimensions
Approx. 182 
× 53 × 161 mm
(7 
1/4
 
× 2 
1/8
 
× 6 
3/8
 
in.) (w/h/d)
Mass
Approx. 1.2 kg
(2 lb. 10 oz.)
Supplied accessories
Card remote commander: RM-X151 (CDX-S2210S/SW330
only) Parts for installation and connections (1 set)
Front panel case (1)
Design and specifications are subject to change without
notice.
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
TEST DISCS
This set can playback CD-R and CD-ROM discs. The following
test discs should be used to check the capability:
CD-R test disc TCD-R082LMT (Part No. J-2502-063-1)
CD-RW test disc TCD-W082L (Part No. J-2502-063-2)
SERVICE NOTES
• E, East European Model
This label is located on the bottom of the chassis.
optical pick-up
semi-fixed resistor
3
z
 UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
 : LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40
°C higher than
ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350
°C.
Caution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
CDX-S2210/S2210S/S2210X/S2250EE/SW330
• CD Playback:
You can play CD-DA (also containing CD TEXT*
1
), CD-R/CD-
RW (MP3 files also containing Multi Session and ATRAC CD
(ATRAC3 and ATRAC3plus format).
Type of discs
Label on the disc
CD-DA
MP3
ATRAC CD
*1 A CD TEXT disc is a CD-DA that includes information such as
disc, artist and track name.
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension cable)
as shown below.
• Connect the MAIN board (CNP301) and the SERVO board (CN2)
with the extension cable (Part No. J-2502-076-1).
SERVO BOARD
CN2
MAIN BOARD
CNP301
J-2502-076-1
4
CDX-S2210/S2210S/S2210X/S2250EE/SW330
TABLE OF CONTENTS
1. GENERAL
Location of controls and basic operations (CDX-S2210) ....... 5
Location of controls and basic operations (CDX-S2250EE) .. 5
Location of controls and basic operations
(CDX-S2210S/S2210X) .......................................................... 5
Location of controls and basic operations (CDX-SW330) ..... 6
Connections (CDX-S2210) ..................................................... 7
Connections (CDX-S2210S/S2210X) ..................................... 8
Connections (CDX-S2250EE) ................................................ 9
Connections (CDX-SW330) .................................................. 10
2. DISASSEMBLY
2-1.   Sub Panel (LCD) Assy ...................................................... 11
2-2.   CD Mechanism Block ....................................................... 12
2-3.   Main Board ....................................................................... 12
2-4.   Chassis (T) Sub Assy ........................................................ 13
2-5.   Roller Arm Assy ................................................................ 13
2-6.   Chassis (OP) Assy ............................................................. 14
2-7.   Optical Pick-up ................................................................. 14
2-8.   SL Motor Assy (M902) ..................................................... 15
2-9.   LE Motor Assy (M903) ..................................................... 15
2-10. Servo Board ....................................................................... 16
3. DIAGRAMS
3-1.   Block Diagram –CD Section– ........................................... 17
3-2.   Block Diagram –Main Section– ........................................ 18
3-3.   Block Diagram –Display Section– .................................... 19
3-4.   Printed Wiring Boards –SERVO Board– .......................... 21
3-5.   Schematic Diagram –SERVO Board (1/2)– ...................... 22
3-6.   Schematic Diagram –SERVO Board (2/2)– ...................... 23
3-7.   Printed Wiring Board –Main Board– ................................ 24
3-8.   Schematic Diagram –Main Board (1/4)– .......................... 25
3-9.   Schematic Diagram –Main Board (2/4)– .......................... 26
3-10. Schematic Diagram –Main Board (3/4)– .......................... 27
3-11. Schematic Diagram –Main Board (4/4)– .......................... 28
3-12. Printed Wiring Board –KEY Board– ................................ 29
3-13. Schematic Diagram –KEY Board– ................................... 30
4. EXPLODED VIEWS
4-1.   Main Section ..................................................................... 39
4-2.   Front Panel Section ........................................................... 40
4-3.   CD Mechanism Section (1) (MG-611TA-186//K) ............ 41
4-4.   CD Mechanism Section (2) (MG-611TA-186//K) ............ 42
4-5.   CD Mechanism Section (3) (MG-611TA-186//K) ............ 43
4-6.   CD Mechanism Section (4) (MG-611TA-186//K) ............ 44
5. ELECTRICAL PARTS LIST
......................................... 45
Page of 76
Display

Sony CDX-S2210 / CDX-S2210S / CDX-S2210X / CDX-S2250EE / CDX-SW330 Service Manual ▷ Download

  • DOWNLOAD Sony CDX-S2210 / CDX-S2210S / CDX-S2210X / CDX-S2250EE / CDX-SW330 Service Manual ↓ Size: 9.61 MB | Pages: 76 in PDF or view online for FREE
  • Here you can View online or download the Service Manual for the Sony CDX-S2210 / CDX-S2210S / CDX-S2210X / CDX-S2250EE / CDX-SW330 in PDF for free, which will help you to disassemble, recover, fix and repair Sony CDX-S2210 / CDX-S2210S / CDX-S2210X / CDX-S2250EE / CDX-SW330 Car Audio. Information contained in Sony CDX-S2210 / CDX-S2210S / CDX-S2210X / CDX-S2250EE / CDX-SW330 Service Manual (repair manual) includes:
  • Disassembly, troubleshooting, maintenance, adjustment, installation and setup instructions.
  • Schematics, Circuit, Wiring and Block diagrams.
  • Printed wiring boards (PWB) and printed circuit boards (PCB).
  • Exploded View and Parts List.