CDX-S11, CDX-S11S — Sony Car Audio Service Manual (repair manual)

Model
CDX-S11 CDX-S11S
Pages
49
Size
5.27 MB
Type
PDF
Document
Service Manual
Brand
Device
Car Audio
File
cdx-s11-cdx-s11s.pdf
Date

View Sony CDX-S11 / CDX-S11S Service Manual online

SERVICE MANUAL
Sony Corporation
eVehicle Division
Published by Sony Techno Create Corporation
AEP Model
UK Model
CDX-S11
E Model
CDX-S11/S11S
FM/AM COMPACT DISC PLAYER
CDX-S11: E, EA, MX/S11S
FM/MW/LW COMPACT DISC PLAYER
CDX-S11: AEP, UK
9-879-957-02
2006E04-1
© 2006. 05
Ver. 1.1  2006. 05
SPECIFICATIONS
CDX-S11/S11S
CD player section
Signal-to-noise ratio
120 dB
Frequency response
10 – 20,000 Hz
Wow and flutter
Below measurable limit
Tuner section
FM
Tuning range
87.5 – 108.0 MHz (AEP, UK, EA model)
87.5 – 108.0 MHz (at 50 kHz step)
   (E, MX model)
87.5 – 107.9 MHz (at 200 kHz step)
   (E, MX model)
FM tuning interval
50 kHz/200 kHz switchable (E, MX model)
Aerial terminal
External aerial connector
Intermediate frequency 10.7 MHz/450 kHz
Usable sensitivity
9 dBf
Selectivity
75 dB at 400 kHz
Signal-to-noise ratio
67 dB (stereo), 69 dB (mono)
Harmonic distortion at 1 kHz
0.5% (stereo), 0.3% (mono)
Separation
35 dB at 1 kHz
Frequency response
30 – 15,000 Hz
MW/LW (AEP, UK model)
Tuning range
MW: 531 – 1,602 kHz
LW: 153 – 279 kHz
Aerial terminal
External aerial connector
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity
MW: 30 µV, LW: 40 µV
AM (E, EA, MX model)
Tuning range
531 – 1,602 kHz (EA model)
531 – 1,602 kHz (at 9 kHz step)
   (E, MX model)
530 – 1,710 kHz (at 10 kHz step)
   (E, MX model)
AM tuning interval
9 kHz/10 kHz switchable (E, MX model)
Aerial terminal
External aerial connector
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity
30 µV
• The tuner and CD sections have no adjustments.
Model Name Using Similar Mechanism
NEW
CD Drive Mechanism Type
MG-611XE-186//Q
Optical Pick-up Name
KSS1000E
– Continued on next page –
Photo: CDX-S11S
2
CDX-S11/S11S
SAFETY-RELATED  COMPONENT  WARNING!!
COMPONENTS  IDENTIFIED  BY  MARK  
0
  OR  DOTTED  LINE
WITH  MARK  
0
  ON  THE  SCHEMATIC  DIAGRAMS  AND  IN
THE  PARTS  LIST  ARE  CRITICAL  TO  SAFE  OPERATION.
REPLACE  THESE  COMPONENTS  WITH  SONY  PARTS
WHOSE  PART  NUMBERS  APPEAR  AS  SHOWN  IN  THIS
MANUAL  OR  IN  SUPPLEMENTS  PUBLISHED  BY  SONY.
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
If the optical pick-up block is defective, please replace the whole
optical pick-up block.
Never turn the semi-fixed resistor located at the side of optical pick-
up block.
optical pick-up
semi-fixed resistor
SERVICE NOTES
Power amplifier section
Outputs
Speaker outputs (sure seal connectors)
Speaker impedance
4 – 8 ohms
Maximum power output
45 W 
×
 4 (at 4 ohms)
General
Outputs
Audio outputs terminal
(sub/rear switchable)
Power aerial relay control terminal
Power amplifier control terminal
Inputs
Telephone ATT control terminal
(AEP, UK model)
Aerial input terminal
Tone controls
Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)
Power requirements
12 V DC car battery (negative earth)
Dimensions
Approx. 178 
×
 50 
×
 178 mm
Mounting dimensions
Approx. 182 
×
 53 
×
 161 mm
Mass
Approx. 1.2 kg
Supplied accessories
Parts for installation and connections (1 set)
Design and specifications are subject to change without
notice.
• Abbreviation
EA
: Saudi Arabia model
MX
: Mexican model
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be damaged
by heat.
TEST DISCS
This set can playback CD-R and CD-ROM discs. The following
test discs should be used to check the capability:
CD-R test disc TCD-R082LMT (Part No. J-2502-063-1)
CD-RW test disc TCD-W082L (Part No. J-2502-063-2)
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
3
CDX-S11/S11S
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
 : LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40°C higher than
ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350°C.
Caution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
This label is located on the bottom of the chassis.
• CD Playback:
You can play CD-DA and CD-R/CD-RW for audio use.
SERVO BOARD
CN1
MAIN BOARD
CNP301
J-2502-076-1
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension cable)
as shown below.
• Connect the MAIN board (CNP301) and the SERVO board (CN1)
with the extension cable (Part No. J-2502-076-1).
4
CDX-S11/S11S
TABLE OF CONTENTS
1.
GENERAL
Location of controls and basic operations
(AEP, UK model) ............................................................
5
Connections (AEP, UK model) .......................................
5
Location of controls and basic operations
(E, MX, EA model) .........................................................
7
Connections (E, MX, EA model) ....................................
7
2.
DISASSEMBLY
2-1.
Sub Panel (HEX) Assy .................................................... 10
2-2.
CD Mechanism Block ..................................................... 10
2-3.
Main Board ...................................................................... 11
2-4.
Chassis (T) Sub Assy ....................................................... 11
2-5.
Roller Arm Assy .............................................................. 12
2-6.
Chassis (OP) Assy ........................................................... 12
2-7.
Optical Pick-up ................................................................ 13
2-8.
SL Motor Assy (M902) ................................................... 13
2-9.
LE Motor Assy (M903) ................................................... 14
2-10. Servo Board ..................................................................... 14
3.
DIAGRAMS
3-1.
Block Diagram –CD Section– ......................................... 15
3-2.
Block Diagram –Main Section– ...................................... 16
3-3.
Block Diagram –Key Section– ........................................ 17
3-4.
Circuit Boards Location .................................................. 17
3-5.
Printed Wiring Boards –CD Mechanism Section– .......... 19
3-6.
Schematic Diagram –CD Mechanism Section– .............. 20
3-7.
Printed Wiring Board –Main Section– ............................ 21
3-8.
Schematic Diagram –Main Section (1/3)– ...................... 22
3-9.
Schematic Diagram –Main Section (2/3)– ...................... 23
3-10. Schematic Diagram –Main Section (3/3)– ...................... 24
3-11. Printed Wiring Board
–Key Section (AEP, UK model)– .................................... 25
3-12. Schematic Diagram
–Key Section (AEP, UK model)– .................................... 26
3-13. Printed Wiring Board
–Key Section (Except AEP, UK model)– ........................ 27
3-14. Schematic Diagram
–Key Section (Except AEP, UK model)– ........................ 28
4.
EXPLODED VIEWS
4-1.
Main Section .................................................................... 36
4-2.
Front Panel Section ......................................................... 37
4-3.
CD Mechanism Section (1) ............................................. 38
4-4.
CD Mechanism Section (2) ............................................. 39
4-5.
CD Mechanism Section (3) ............................................. 40
4-6.
CD Mechanism Section (4) ............................................. 41
5.
ELECTRICAL PARTS LIST
.................................. 42
Page of 49
Display

Download Sony CDX-S11 / CDX-S11S Service Manual (Repair Manual)

Here you can view online or download Sony CDX-S11 / CDX-S11S Service Manual in pdf. This Service Manual can help you recover, restore, fix, disassemble and repair Sony CDX-S11 / CDX-S11S Car Audio. Information contained in Sony CDX-S11 / CDX-S11S service manual (repair manual) typically includes:

  • Disassembly, troubleshooting, programming, maintenance, remote, adjustment, installation and setup instructions.
  • Schematics, wiring and block diagrams.
  • Printed wiring boards (PWB) and printed circuit boards (PCB).
  • Parts list (bill of materials).