DOWNLOAD Sony CDX-C880R Service Manual ↓ Size: 10.49 MB | Pages: 68 in PDF or view online for FREE

– 17 –

5

 guide (disc)

1

 PS 2x4

6

 lever (R) assy

7

 lever (L) assy

2

 DISC IN SW board

4

 claws

3

 tension spring (LR)

2

 P 2x3

3

 chassis (T) sub assy

1

 P 2x3

– 18 –

5

 LOAD SW board

4

 PS 2x3

1

 tension spring (RA)

2

 arm (roller)

3

 roller assy

washer

arm

washer

Fig. 1

arm

washers

1

 PS 2x5

3

 heat sink

7

 CN2

0

 SERVO board

6

 PS 2x4

8

 P 2x3

9

 loading motor assy

2

 PS 2x5

5

 CN5

4

 CN4

• When installing, take note of the positions
  arm (roller) and washers. (Fig. 1)

– 19 –

1

 P 2x3

2

 sled motor assy

3

 optical pick-up block

6

 chassis (OP) (O/S) assy

7

 compression spring (FL)

4

 Fit lever (D) in the

     direction of the arrow.

3

 damper (T)

2

 damper (T)

5

 Turn loading ring in the

     direction of the arrow.

1

 tension spring (angle)

8

 compression spring (FL)

– 20 –

FM RF signal
generator

antenna
terminal

0.01 

µ

F

set

Carrier frequency : 98.00 MHz
Output level

: 22 dB (12.6 

µ

V)

Mode

: mono

Modulation

: 1 kHz, 22.5 kHz deviation (30%)

Procedure :
1. Set to the test mode.
2. Push the  SOURCE  button and set to FM.

Display

SOURCE button : FM

3. Push the preset  3  button.

Display

4. Adjust with the volume RV2 on TU10 so that the “FM”

indication turns to “FM0” indication on the display window.
But, in case of already indicated “FM0”, turn the RV2 so that
put out light “0” indication and adjustment.

Display

CD section adjustments are done automatically in this set.

When the tuner unit is defective, replace it by a new one
because its internal block is difficult to repair.

This set have the test mode function. In the test mode, FM Auto
Scan/Stop Level and MW Auto Scan/Stop Level adjustments can
be performed easier than it in ordinary procedure.

<Set the Test Mode>
1. Set the “OFF” mode.
2. Push the preset  4  button.
3. Push the preset  5  button.
4. Press the preset  1  button for more than two seconds.
5. Then the display indicates all lights, the test mode is set.

<Release the Test Mode>
1. Push the  OFF  button.

The adjustments of tuner section, should be performed according
to the following sequence.
1. FM Auto Scan/Stop Level Adjustment
2. FM Stereo Separation Adjustment (WIDE)
3. FM Stereo Separation Adjustment (NARROW)
4. FM RDS S-Meter Adjustment
5. MW Auto Scan/Stop Level Adjustment

µ

Adjustment Location : See page 23.