DOWNLOAD Sony CDX-4170R Service Manual ↓ Size: 1.27 MB | Pages: 45 in PDF or view online for FREE

– 17 –

4

 chassis (T) sub assy

2

 P 2x3

3

 P 2x3

1

 Unsolder the

     lead wires.

red

white

black

4

 claws

2

 DISC IN SW board

7

 lever (L) assy

3

 tension spring (LR)

6

 lever (R) assy

5

 guide (disc)

1

 PS 2x4

– 18 –

• When installing, take note of the positions
  arm (roller) and washers. (Fig. 1)

5

 PS 2x4

1

 CN3

3

 P 2x3

4

 loading motor assy

9

 SERVO board

2

 CN2

8

 sheet (driver)

7

 bracket (driver)

6

 PS 2x5

4

 PS 2x3

5

 LOAD SW board

1

 tension spring (RA)

2

 arm (roller)

3

 roller assy

washer

arm

arm

washer

washers

– 19 –

1

 P 2x3

2

 sled motor assy

3

 optical pick-up block

1

 tension spring (angle)

8

 compression spring (FL)

7

 chassis (OP) (O/S) assy

9

 compression spring (FL)

2

 tension spring (KR1)

5

 Fit lever (D) in the

     direction of the arrow.

3

 damper (T)

4

 damper (T)

6

 Turn loading ring in the

     direction of the arrow.

– 20 –

This set have the test mode function. In the test mode, FM Auto
Scan/Stop Level and MW Auto Scan/Stop Level adjustments can
be performed easier than it in ordinary procedure.

<Set the Test Mode>
1. Set the “OFF” mode.
2. Push the preset  4  button.
3. Push the preset  5  button.
4. Press the preset  1  button for more than two seconds.
5. Then the display indicates all lights, the test mode is set.

<Release the Test Mode>
1. Push the  OFF  button.

When the tuner unit is defective, replace it by a new one because
its internal block is difficult to repair.

The adjustments of tuner section, should be performed according
to the following sequence.
1. FM Auto Scan/Stop Level Adjustment
2. FM Noise Focus Adjustment
3. FM Stereo Separation Adjustment
4. FM RDS S-Meter Adjustment
5. MW Auto Scan/Stop Level Adjustment

µ

Carrier frequency : 98.00 MHz
Output level

: 22 dB (12.6 

µ

V)

Mode

: mono

Modulation

: 1 kHz, 22.5 kHz deviation (30%)

Procedure :
1. Set to the test mode.
2. Push the  SOURCE  button and set to FM.

Display

D-BASS switch : OFF
SOURCE button : FM

3. Push the preset  3  button.

Display

4. Adjust with the volume RV2 on TU101 so that the “FM”

indication turns to “FM0” indication on the display window.
But, in case of already indicated “FM0”, turn the RV2 so that
put out light “0” indication and adjustment.

Display

FM RF signal

generator

0.01 

µ

F

antenna
terminal

set

Adjustment Location : See page 22.