Sony TCS-60DV Service Manual ▷ View online
— 4 —
SECTION 2
GENERAL
This section is extracted
from instruction manual.
from instruction manual.
!™ Tape direction indicators
!£ SPEAKER (REAR SIDE)
!¢ TAPE COUNTER switch
!∞ Flat mic
!§ PAUSE c switch
!£ SPEAKER (REAR SIDE)
!¢ TAPE COUNTER switch
!∞ Flat mic
!§ PAUSE c switch
!¶ REC TIME switch
!• BATT/REC indicator
!ª VOR switch
@º Battery compartment
@¡ i indicator
@™ DC IN 3V jack
!• BATT/REC indicator
!ª VOR switch
@º Battery compartment
@¡ i indicator
@™ DC IN 3V jack
1 2 Headphone jack
2 MIC (PULG IN POWER) jack
3 VOL knob
4 r REC button
3 VOL knob
4 r REC button
5 p STOP button
6 PLAY button
7 SPEED CONTROL knob
8 REW/REVIEW button
9 FF/CUE button
0 DIR c switch
7 SPEED CONTROL knob
8 REW/REVIEW button
9 FF/CUE button
0 DIR c switch
!¡ Hand strap
— 5 —
SECTION 3
DISASSEMBLY
Disassemble the unit in the order as shown below.
Note :
Follow the disassembly procedure in the numerical order given.
3-1. “CABINET (REAR) ASSY”, “LID SUB ASSY, CASSETTE”
Set
"Cabinet (rear) assy", "lid sub assy, cassette"
Main board, Mechanism deck
Belt
Head
Motor, dc
3-2. MAIN BOARD, MECHANISM DECK
1
Two screws(+B1.7
×
9)
2
Two screws(+B1.7
×
9)
4
Remove speaker cable (4pcs)
5
PWB, LED Flexible
6
Shaft(A), stopper
7
Screw, ornamental
8
Screw, ornamental
9
Lid Sub Assy, Cassette
Claws
3
Remove the Cabinet (rear) assy
in the direction of the allow
Claws
5
PC board, Motor flexible
1
Three screws(IB LOCK)
8
Mechanism deck
6
PC board, Head flexible
3
Two screws(M1.4), Toothed lock
7
MAIN board
2
4
NOTE: For attaching the Main board,
refer to the next page.
— 6 —
3-3. BELT
1
Belt(motor)
Belt(motor)
2
Belt(flywheel)
Belt(flywheel)
3
Belt(counter)
Belt(counter)
• How to thread the belt
3-4. HEAD
1
two screws
2
head, magnetic
(REC/PB/ERASE)
— 7 —
— 7 —
3-5. MOTOR, DC
3-6. PRECAUTION FOR ATTACHING THE MAIN BOARD
MAIN board
S303
S302
S701
Mechanism deck
• Attach the knobs of the switches S302, S303, and S701 on the Main board
while aligning them with the claws of the REC lever, write-protection 2
lever, and the PAUSE lever respectively.
lever, and the PAUSE lever respectively.
PAUSE lever (align it with S701)
Write-protection lever
(align it with S303)
(align it with S303)
REC lever
(align it with S302)
(align it with S302)
3 Remove the four solders.
1 screw (1.4)
2 screw (1.4)
4 Motor, DC