Sony SRF-M73 Service Manual ▷ View online
– 2 –
TABLE OF CONTENTS
1.
SERVICING NOTES
...............................................
2
2.
GENERAL
...................................................................
3
3.
DISASSEMBLY
.........................................................
4
4.
ELECTRICAL ADJUSTMENTS
.........................
6
5.
DIAGRAMS
5-1. Block Diagram ................................................................
8
5-2. Printed Wiring Boards ..................................................... 10
5-3. Schematic Diagram ......................................................... 13
5-4. IC Pin Function Description ........................................... 18
5-3. Schematic Diagram ......................................................... 13
5-4. IC Pin Function Description ........................................... 18
6.
EXPLODED VIEWS
................................................ 19
7.
ELECTRICAL PARTS LIST
............................... 20
Forced Reset
The system microprocessor can be reset in the following proce-
dure.
Use these procedure when the unit cannot be worked normally
due to the overrunning of the microprocessor, etc.
dure.
Use these procedure when the unit cannot be worked normally
due to the overrunning of the microprocessor, etc.
Procedure:
1. Set to radio OFF.
2. While pressing the
1. Set to radio OFF.
2. While pressing the
[SCAN]
button, press two buttons of
[START/
STOP]
and
[BAND]
simultaneously for 5 seconds.
3. The unit is reset, and display blinking “
AM
12:00
”.
SECTION 1
SERVICING NOTES
– 3 –
SECTION 2
GENERAL
This section is extracted from
instruction manual.
instruction manual.
– 4 –
CABINET (FRONT)/(REAR) ASSY
KEY BOARD
·
This set can be disassembled in the order shown below.
SECTION 3
DISASSEMBLY
Set
Key Board
Main Board
Knob (A)
Cabinet (Rear) Assy
Cabinet (Front) Assy
2
three screws
(B1.7
(B1.7
×
8)
2
two screws
(B1.7
(B1.7
×
8)
1
Remove the battery case lid
of the arrow.
of the arrow.
3
cabinet (front) assy
4
cabinet (rear) assy
1
three claws
2
Open the key board
to direction of the arrow.
to direction of the arrow.
1
four claws
Note:
Follow the disassembly procedure in the numerical order given.
– 5 –
MAIN BOARD
KNOB (A)
Note: Check that two switch (S1,
S2) is latched with two
adaptors when carrying
out installation.
adaptors when carrying
out installation.
2
screw
(B1.7
(B1.7
×
8)
1
Remove two solders.
3
knob (vol)
4
two claws
S1
S2
5
main board
2
two knobs (A)
1
claw
1
claw
3
two adaptors