DOWNLOAD Sony NWZ-S754 / NWZ-S755 Service Manual ↓ Size: 1.15 MB | Pages: 34 in PDF or view online for FREE

•  This set can be disassembled in the order shown below.

Note: Follow the disassembly procedure in the numerical order given.

4

1 

u 5.5)

3 

5 

6 

2 

2 

Note: When installing panel (rear) assy 
 

block, the position of switch and 

 

support (hold) is set and installed.

2 

2 

1 

4 

5 

3

6 

 Note: When the main block is installed in the mechanical 
 

 

front assy block, it is necessary to install the cover 

 

 

(LCD) to main block first.

 

 

Please install the main block on the mechanical front 

 

 

assy block after it install cover (LCD) on the main 

 

 

block referring to “2-4. MECHANICAL FRONT 

 

 

ASSY” on page 11 and “2-9. LCD ASSY (LCD1)”

 

 

on page 14.

6 mechanical front assy

1 

2 

3 

4 adhesive sheet (cover LCD)

Note 1: The adhesive sheet (cover LCD) cannot be reused. 

  

Please exchange it for new parts when you remove

 

 

the adhesive sheet (cover LCD).

5 cover (LCD)

Note 2: The cover (LCD) is necessary to fix the cover light pasted to the main block.

 

 

Please refer to “2-9. LCD ASSY (LCD1)” on page 14 when you install it.

Note 1: This illustration sees the mechanical commonness block from LCD assy side (lower half).
Note 2: Make sure to remove one solder to become an open state before disassembling the mechanical commonness  block.
Note 3: Solder the short-land after all wirings are connected when you exchanged some mounted board.

Note 1: The EMMC board cannot exchange with single. When exchanging the EMMC board, exchange it at the same time as the MOTHER board.

1 Remove the solder of short-land (SL9501).

3

1 cushion (NAND)

4 EMMC board

2 connector

Note 2: Lift vertically the EMMC board 

  

when you remove the connector.