Sony MDS-MX101 Service Manual ▷ View online
— 6 —
3-5.
BRACKET (T), (L) AND (R)
3-4.
OPJ BOARD, POWER BOARD
2
Bracket (T)
1
Four screws
(BVTT 2x3)
4
Screw (BVTT 2x3)
3
Screw (BVTT 2x3)
5
Bracket (joint)
7
Bracket (L)
9
Bracket (R)
8
Two screws
(BVTT 2x3)
6
Two screws
(BVTT 2x3)
8
Power board
5
Two screws
(BVTT 3x8)
1
Two screws
(BVTP 3x8)
5
Two screws
(BVTT 3x8)
6
Flat type wire
(23 Core)
7
Flat type wire
(13 Core)
1
Two screws
(BVTP 3x8)
1
Three screws
(BVTP 3x8)
4
Opj board
3
Cord (with Connector)
(CN102)
2
Back Panel
— 7 —
3-6.
BD BOARD
4
OP relay fiexible board
(CN101)
5
BD board
3
Screw (BVTT 2x4)
1
Flexible board
(Over write head)
2
Flat type wire (15 Core)
(CN106)
3-7.
SUB CHASSIS
1
Two step screws
2
Two step screws
3
Two insulatores
4
Two insulatores
5
Sub chassis
Part A
Part A
Part A
NG
OK
Take care so that hte part A
may be right position when installing.
may be right position when installing.
— 8 —
3-8.
SHUTTER ASSEMBLY
1
Stopper washer
2
Shaft (shutter)
Shaft (shutter) A
Shaft (lid) B
3
Shutter assembly
Shutter assembly
Hole B
Hole A
When installing, install the shaft (shutter)
into the hole A as shown in the figure
before installing the shaft (lid) into the hole B.
into the hole A as shown in the figure
before installing the shaft (lid) into the hole B.
3-9.
OVER WRITE HEAD
1
Precision screw (P1.7x6)
2
Over write head
— 9 —
3-10 . SLIDER COMPLETE ASSEMBLY
• Note for Installation of Slider Complete Assembly
45
°
OK
NG
3
Set the shaft of Gear (LA) to be at the
position in the figure.
2
Retainer (Gear)
1
Screw
(M1.7x2)
4
Remove the slider complete
assembly in the direction of
arrow with putting out of
two claws.
arrow with putting out of
two claws.
Claw
Claw
Slider assembly
Install the part A of leever (head up)
to pass over the slider complete assembly.
to pass over the slider complete assembly.
Part A
Take care not to damage
the detective switch.
the detective switch.
Click on the first or last page to see other MDS-MX101 service manuals if exist.