Sony HMZ-T1 Service Manual ▷ View online
HMZ-T1
2-7
2-2-5.
FORHEAD SUPPORT / DISPLAY UNIT
② FORHEAD SPRING
④ FORHEAD SUPPORT
・DISPLAY UNIT
Note: Be sure not to fold two FFCs when handling the DISPLY UNIT.
⑥ four harnesses
(CN101/903/1001/1002)
⑦ DISPLAY UNIT
※ Do not fold.
③ two screws (P2x4)
① screw (P2x4)
⑤ seven screws (P2x4)
HMZ-T1
2-8
2-2-6. HP HANGER ASSY (L) / HP HANGER ASSY (R)
Note: Following images are (L) side. Disassemble the (R) side same as (L) side because of similar design.
③ harness (CN1002)
④ HP HANGER ASSY (L)
2-2-7. HP UNIT ASSY (L) / HP UNIT ASSY (R)
② HANGER COVER (L)
① three flat head screws
② screw (B2)
① four screws (P2x4)
④ HP SLIDER
⑤ HP SLIDER SPRING
⑥ HP SLIDE COVER (L)
⑦ HP UNIT ASSY (L)
③ two screws (P2x4)
② screw (B2)
② washer
(LW2, TYPE(A)
HMZ-T1
2-9
[Note]
If the wiring of the HP harness is so tight, the HP UNIT ASSY will not move smoothly. In reassembling, position the harness
as follws to make comfortable allowance.
If the wiring of the HP harness is so tight, the HP UNIT ASSY will not move smoothly. In reassembling, position the harness
as follws to make comfortable allowance.
② Slide the HP SLIDER to the arrow direction.
① Pass the harness through the
incision of HP SLIDER.
HP SLIDER
HP harness
③ Down the HP UNIT ASSY to the
arrow direction.
HP UNIT ASSY
④ Position the harness as above
pulling it not to make slack.
※ Hold the harness between dowels. (seven points)
⑤ Finally fix the harness with
a nonwoven fabric tape.
Nonwoven Fabric Tape
HMZ-T1
2-10E
2-2-8. BUTTON ASSY (L) / BUTTON ASSY (R)
③ four screws (SCW +P1.4)
④ HEAD BAND PLATE (L)
⑤ BUTTON ASSY (L)
Note: Following images are (L) side. Disassemble the (R) side same as (L) side because of similar design.
② HANGER COVER (L)
① four screws (P2x4)
④
Click on the first or last page to see other HMZ-T1 service manuals if exist.