Sony HCD-VX222 / MHC-VX222 Service Manual ▷ View online
4
HCD-VX222
SECTION 1
SERVICE NOTE
1
Connector
13p (CN712)
2
Cut the seven melted-connection points
with a cutting plier.
4
Cut the six melted-connection points
with a cutting plier.
3
Panel board
5
Key board
Panel board
(ten screw holes)
(ten screw holes)
Key board
(eight screw holes)
(eight screw holes)
Screw hole
In order to re-install the panel board and the key board,
fix them by using the screws (+BVTP 2.6
fix them by using the screws (+BVTP 2.6
×
8 ) respectively.
Screw in to the respective screw holes.
Do not tighten the screws excessively.
Do not tighten the screws excessively.
* The panel board and the key board only are connected to the front panel
by means of hot-melting the plastics.
by means of hot-melting the plastics.
Note for installing the panel board and the key board
REMOVING THE PANEL BOARD AND THE KEY BOARD
Hot melt
5
HCD-VX222
This section is extracted from
instruction manual.
instruction manual.
SECTION 2
GENERAL
6
HCD-VX222
Setting the time
1
Turn on the system.
2
Press CLOCK/TIMER SET on the
remote.
remote.
Proceed to step 5 when “CLOCK” appears
in the display.
in the display.
3
Press v or V
v
V
V
repeatedly to select “SET
CLOCK”.
4
Press ENTER.
5
Press
or
v
repeatedly to set the hour.
6
Press .
The minute indication flashes.
7
Press or repeatedly to set the
minute.
minute.
8
Press ENTER.
Tip
If you made a mistake or want to change the time,
start over from step 2.
start over from step 2.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
the power cord or if a power failure occurs.
B
7
HCD-VX222
SECTION 3
DISASSEMBLY
3-1. CASE (SIDE-R, SIDE-L, TOP)
Note : Disassemble the unit in the order as shown below.
Note : Follow the disassembly procedure in the numerical order given.
Driver board, Moter board, Address sensor board
Chassis section
Case (Side-R, Side-L, Top)
CD door
Front panel section
CD mechanism deck
(CDM58B)
(CDM58B)
Key board
Panel board
Tape mechanism deck
Sub trans board, Video out board, Back panel, Power transformer
(Trans board)
(Trans board)
Main board, Power amp board
Video board, Base unit, BD board
Set
Case (Side-R)
Case (Side-L)
5
qd
qs
qs
q;
Case (Top)
6
Two screws (Case 3 TP2)
8
Screw
(+BVTP 3
×
10)
3
Screw
(+BVTP 3
×
10)
9
Screw
(+BVTT 3
×
8)
4
Screw
(+BVTT 3
×
8)
1
Two screws
(Case 3 TP2)
qa
Two screws (+BVTP 3
×
12)
7
Screw (Case 3 TP2)
2
Screw (Case 3 TP2)