Sony HCD-S550 / HCD-S880 Service Manual ▷ View online
5
HCD-S550/S880
SECTION 1
SERVICING NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
JIG ON REPAIRING
When repairing this set, etc., connect the extension cable as the
figure shown below.
figure shown below.
extension cable
(RF board-DVD board)
(Part No. J-2501-217-A)
(RF board-DVD board)
(Part No. J-2501-217-A)
extension cable (with relay board)
(RELAY board-DVD board)
(Part No. J-2501-091-A)
(RELAY board-DVD board)
(Part No. J-2501-091-A)
extension cable
(DVD board-AMP board)
(Part No. J-8000-024-A)
(DVD board-AMP board)
(Part No. J-8000-024-A)
extension cable
(DVD board-AMP board)
(Part No. J-2501-198-A)
(DVD board-AMP board)
(Part No. J-2501-198-A)
RELEASING THE DISC SLOT LOCK
The disc slot lock function for the antitheft of an demonstration
disc in the store is equipped.
disc in the store is equipped.
Releasing Procedure:
1. Press two buttons of
1. Press two buttons of
A
and
x
simultaneously for three sec-
onds.
2. The message “UNLOCKED” is displayed and the slot is un-
locked.
Note:
When “LOCKED” is displayed, the slot lock is not released by
turning power on/off with the
turning power on/off with the
[POWER]
button.
Ver 1.6
NOTE OF REPLACING THE DVD BOARD
When replacing the DVD board, since the adjustment value is not
set up correctly, “Drive Auto Adjustment” can’t be performed.
In this case, initialize Memory in the following procedures.
set up correctly, “Drive Auto Adjustment” can’t be performed.
In this case, initialize Memory in the following procedures.
Procedure:
1. Set the test mode. (See page 20)
2. Press the
1. Set the test mode. (See page 20)
2. Press the
[2]
key of the remote commander, and set the “DRIVE
MANUAL OPERATION”. (See page 22)
3. Press the
[6]
key of the remote commander, and set the “2-6,
Memory Check”. (See page 24)
4. Press the
[CLEAR]
key of the remote commander, and initial-
ize Memory.
CHECKING OF OPERATIONS WITH REMOTE COM-
MANDERS OF DIFFERENT MODELS
MANDERS OF DIFFERENT MODELS
Some of the signal of remote commander vary between genera-
tion of player.
Between DAV-S400/S500/S800/C450/C700/C900 and DAV-S550/
S880/C770/C900, remote commander signal codes of “FUNC-
TION”, “BAND”, “ST/MONO” and “MEMORY” are different.
Take notice of the above when you check the operation with re-
mote commanders of different models.
tion of player.
Between DAV-S400/S500/S800/C450/C700/C900 and DAV-S550/
S880/C770/C900, remote commander signal codes of “FUNC-
TION”, “BAND”, “ST/MONO” and “MEMORY” are different.
Take notice of the above when you check the operation with re-
mote commanders of different models.
6
HCD-S550/S880
SECTION 2
GENERAL
This section is extracted from
instruction manual.
instruction manual.
LOCATION OF CONTROLS
Front Panel
1 POWER switc
2 STANDBY indicator
3 Disc slot
4
2 STANDBY indicator
3 Disc slot
4
A (Eject)
5
H (play)
6
X (pause)
7
x (stop)
8
./> PREV/NEXT, PRESET –/+
9 PHONES jack
q; VOLUME control
qa SOUND FIELD –/+
qs DISPLAY
qd BAND
qf FUNCTION
qg Front panel display
qh
q; VOLUME control
qa SOUND FIELD –/+
qs DISPLAY
qd BAND
qf FUNCTION
qg Front panel display
qh
(remote sensor)
FUNCTION
BAND
DISPLAY
SOUND FIELD
PHONES
STANDBY
1 SPEAKER jacks
2 AM antenna
3 COMPONENT VIDEO OUT/SCAN
2 AM antenna
3 COMPONENT VIDEO OUT/SCAN
SELECT switch
4 VIDEO 1 jacks
5 VIDEO 2 jacks
5 VIDEO 2 jacks
6 DIGITAL IN (OPTICAL) jack
7 MONITOR OUT (VIDEO/S VIDEO)
7 MONITOR OUT (VIDEO/S VIDEO)
jacks
8 COMPONENT VIDEO OUT jacks
9 FM 75Ω COAXIAL antenna jack
9 FM 75Ω COAXIAL antenna jack
Rear Panel
WOOFER 3Ω
IMPEDANCE
USE
EXCEPT
WOOFER 3Ω
WOOFER 3Ω
INTERLACE
SELECTABLE
SCAN SELECT
SPEAKER
VIDEO 1
VIDEO 2
COMPONENT VIDEO OUT
MONITOR
OUT
COMPONENT
VIDEO OUT
FRONT
R
FRONT
L
R E A R
R
R E A R
L
CENTER
WOOFER
COAXIAL
AUDIO OUT
L
R
L
R
L
R
VIDEO OUT
VIDEO IN
OPTICAL
DIGITAL
IN
AUDIO IN
AUDIO IN
VIDEO IN
Y
P
B
/C
B
P
R
/C
R
AM
FM
75Ω
V I D E O
S VIDEO (DVD ONLY)
7
HCD-S550/S880
When playing back a Super Audio CD, CD, VIDEO CD, or MP3
When listening to the radio
FM AM
TUNED
MONO ST
MHz
Current band
Preset number
Monaural/Stereo effect
Current station
Playing status
Current track number
Current play mode
Lights up during
PBC playback
(VIDEO CD only)
PBC playback
(VIDEO CD only)
Playing time
SACD
PCM
TRACK
INDEX
M
S
SHUFFLE
PROG PBC
REPEAT 1
Current index number
(The index indicator does not appear
during Super Audio CD or MP3
playback.)
(The index indicator does not appear
during Super Audio CD or MP3
playback.)
Playing status
Current title
number
number
Playing time
Current repeat mode
Current chapter number
Current surround
format
format
Front Panel Display
When playing back a DVD
DIGITAL
PCM
PRO LOGIC
TITLE
CHAPTER
H
M
S
REPEAT 1
ANGLE
Current sound
Current sound
Lights up when you can
change the angle
change the angle
8
HCD-S550/S880
Remote
1
2
3
4
5
6
7
>10
10/0
8
9
1 TV [/1 (on/standby)
2
Z (EJECT)
3 NAME
4 STEREO/MONO
5 MEMORY
6 CLEAR
4 STEREO/MONO
5 MEMORY
6 CLEAR
7 PLAY MODE
8 AUDIO
9 ANGLE
q; SUBTITLE
qa VOL +/–
qs
8 AUDIO
9 ANGLE
q; SUBTITLE
qa VOL +/–
qs
./> PREV/NEXT, TV CH –/+,
PRESET –/+
PRESET –/+
qd
H PLAY/SELECT
qf DVD TOP MENU
qg DVD DISPLAY
qh C/X/x/c/ENTER
qj DVD SETUP
qk
qg DVD DISPLAY
qh C/X/x/c/ENTER
qj DVD SETUP
qk
1 (standby)
ql DIMMER
w; TV/VIDEO
wa REPEAT
ws MUTING
wd TIME
wf FUNCTION
w; TV/VIDEO
wa REPEAT
ws MUTING
wd TIME
wf FUNCTION
wg BAND
wh Number buttons
wj SOUND FIELD
wk DISPLAY
wl ENTER
e; COMMAND MODE DVD TV switch
wh Number buttons
wj SOUND FIELD
wk DISPLAY
wl ENTER
e; COMMAND MODE DVD TV switch
ea
m/M/
/
SLOW, TUNING –/+
es
x STOP
ed
X PAUSE
ef DVD MENU
eg
eg
O RETURN
eh AMP MENU
Note
This remote control glows in the dark. However,
before glowing, the remote must be exposed to light
for awhile.
before glowing, the remote must be exposed to light
for awhile.
Click on the first or last page to see other HCD-S550 / HCD-S880 service manuals if exist.