Sony HCD-FX350I Service Manual ▷ View online
HCD-FX350i
4
CAPACITOR ELECTRICAL DISCHARGE PROCESSING
When checking the board, the electrical discharge is necessary for
the electric shock prevention.
Connect the resistors referring to the fi gure below.
• PT board (C905)
• MAIN board (C903, C904)
Both ends of respective capacitors.
When checking the board, the electrical discharge is necessary for
the electric shock prevention.
Connect the resistors referring to the fi gure below.
• PT board (C905)
• MAIN board (C903, C904)
Both ends of respective capacitors.
– PT Board (Conductor Side) –
– MAIN Board (Conductor Side) –
800
:/2 W
800
:/2 W
800
:/2 W
C905
C903
C904
HCD-FX350i
5
SECTION 2
DISASSEMBLY
• This set can be disassembled in the order shown below.
2-1. DISASSEMBLY FLOW
2-3. TOP PANEL BLOCK
(Page
(Page
6)
2-2. PANEL (REAR) BLOCK
(Page
(Page
5)
2-7. BASE
UNIT
(Page
8)
2-4. FRONT PANEL BLOCK
(Page
(Page
6)
2-8. OPTICAL PICK-UP BLOCK
(DA11MMVGP)
(Page
(DA11MMVGP)
(Page
8)
2-5. KNOB
(VOL)
(Page
7)
2-6. MODULE (DAB TUNER) BLOCK,
MAIN
MAIN
BOARD
(Page
7)
SET
Note: Follow the disassembly procedure in the numerical order given.
2-2. PANEL (REAR) BLOCK
Note: This illustration sees the set from rear side.
3
2 two screws
(BVTP3
u 10)
4 panel (rear) block
1 three screws
(BVTP3
u 8)
2 four screws
(BVTP3
u 10)
HCD-FX350i
6
2-3. TOP PANEL BLOCK
Note: This illustration sees the set from rear side.
2-4. FRONT PANEL BLOCK
1 connector
(SW880)
3 connector
(CN914)
7 top panel block
4 claw
4 claw
2 flexible flat cable (15 core) (CN401)
6 three claws
5
qd front panel block
5 lead wire (from IP board)
qa claw
6 lead wire (from PANEL board)
8 lead wire (from
PANEL
board)
4 screw (BV3)
3 flexible flat cable (21 core) (CN912)
1 connector (CN913)
qs
qa claw
0 screw
(BVTP3
u 8)
7 screw (BV3)
9 floating screw (PTPWH M2.6)
2 Lift up the lead pin.
(AEP,
UK)
UK)
(AEP, UK)
(AEP, UK)
Ver. 1.1
HCD-FX350i
7
2-6. MODULE (DAB TUNER) BLOCK, MAIN BOARD
2-5. KNOB
(VOL)
Note: This illustration sees the front panel block from PANEL board side.
3 connector
(CN904)
1 connector (CN901)
0 MAIN board
4 two screws (BV3)
6 screw
(BVTP3
u 8)
2 connector
(CN902)
5
9 module (DAB tuner) block
7 wire
8
2 knob (VOL)
hole
1 Push the knob (VOL)
by flat-head screwdriver.
front panel block
PANEL board