Sony HCD-BX2 / HCD-DX2 / HCD-DX2B / MHC-BX2 / MHC-DX2 / MHC-DX2B Service Manual ▷ View online
5
This section is extracted from
instruction manual.
instruction manual.
1
Press CLOCK/TIMER SET.
The hour indication flashes.
.
nN
X
x
m
M
>
Step 2: Setting the
time
time
You must set the time before using the timer
functions.
functions.
The clock uses a 24-hour system on the
European model, and a 12-hour system on
other models.
European model, and a 12-hour system on
other models.
The 12-hour system is used for illustration
purposes.
purposes.
1
3,5
2,4
2
Press . or > repeatedly to set
the hour.
the hour.
3
Press ENTER.
The minute indication flashes.
4
Press . or > repeatedly to set
the minute.
the minute.
5
Press ENTER.
The clock starts working.
Tip
If you make a mistake, start over from step 1.
To change the time
The previous explanation shows how to set
the time while the power is off. To change the
time while the power is on, do the following:
the time while the power is off. To change the
time while the power is on, do the following:
1 Press CLOCK/TIMER SET.
2 Press . or > repeatedly to select SET
2 Press . or > repeatedly to select SET
CLOCK.
3 Press ENTER.
4 Perform steps 2 through 5 above.
4 Perform steps 2 through 5 above.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
the power cord or if a power failure occurs.
6
Note:
Follow the disassembly procedure in the numerical order given.
SECTION 3
DISASSEMBLY
CD DOOR
CD ASS’Y
1
Pull out the CD tray.
4
Push the CD tray.
2
five claws
3
CD door
1
screw
4
four claws
6
wire (flat type) (22core)
(CN705)
(CN705)
1
screw
2
two screws
3
8
CD ass'y
7
wire (6core)
(CN301)
(CN301)
5
connector
(CN703)
(CN703)
CD TRAY (Page 10)
7
FRONT PANEL
6
screw
2
connector
1
wire (flat type) (16core)
5
three screws
6
screw
CN601
3
wire (flat type)
(CN702)
(CN702)
4
two rivets
2
connector
(CN201)
(CN201)
8
front panel section
7
two claws
MECH DECK (CWL-44-FR)
1
six screws
2
harness
3
mech deck (CWL-44-FR)
8
POWER TRANSFORMER (T001)
REAR COVER
2
rear cover
1
eight screws
1
screw
1
two screws
1
four screws
3
four screws
4
power transformer (T001)
1
Remove two solders.
2
connector
(CN803)
(CN803)
Click on the first or last page to see other HCD-BX2 / HCD-DX2 / HCD-DX2B / MHC-BX2 / MHC-DX2 / MHC-DX2B service manuals if exist.