Sony HBD-DZ330 / HBD-DZ710 / HBD-DZ730 Service Manual ▷ View online
HBD-DZ330/DZ710/DZ730
9
Note: Follow the disassembly procedure in the numerical order given.
2-1. CASE
8
case
6
Raise one side of the case.
1
two screws
(+BV3 (3-CR))
2
two screws
(+BV3 (3-CR))
3
four screws
(+BV3 (3-CR))
4
screw
(+BV3 (3-CR))
5
7
HBD-DZ330/DZ710/DZ730
10
2-2. LOADING PANEL
2-3. FRONT PANEL SECTION
3
loading panel
tray
1
2
Insert a screwdriver from between the front panel
and the chassis and slide the rod in the direction
of the arrow.
and the chassis and slide the rod in the direction
of the arrow.
1
two screws
(+BV3 (3-CR))
5
four screws
(+BV3 (3-CR))
6
four claws
9
three claws
7
claw
8
claw
0
2
two ground plate (front)
3
knob vol (DSZ)
4
nut
qa
CN5202 (4P)
qs
front panel section
HBD-DZ330/DZ710/DZ730
11
2-4. FL BOARD, ENCODER BOARD, JACK BOARD, USB BOARD
1
wire (flat type) (13 core) (CN5005)
(DZ330/DZ730)
wire (flat type) (15 core) (CN5002)
(DZ710)
wire (flat type) (15 core) (CN5002)
(DZ710)
2
screw
(+BV3 (3-CR))
3
screw
(+BV3 (3-CR))
qs
screw
(+BV3 (3-CR))
9
two screws
(+BV3 (3-CR))
4
CN5006 (2P) (DZ330/DZ730)
CN5003 (4P) (DZ710)
8
CN4007 (4P) (DZ330/DZ730)
CN4011 (4P) (DZ710)
5
FL board
0
JACK board
qd
JACK board
MAIN board
7
ENCODER board
6
claw
qa
CN2101 (5P)
Arranging the USB wire
USB wire
USB wire
Tie up with LP501.
Thread the USB wire through
the capacitors.
the capacitors.
The USB wire should be located on the front side
from these capacitors.
from these capacitors.
Dress the USB wire in this area
properly along the board.
properly along the board.
Have the USB wire spread on the inside
of the claws of the chassis.
of the claws of the chassis.
HBD-DZ330/DZ710/DZ730
12
2-5. KEY-SW BOARD, P-SW BOARD
3
eight claws
5
two claws
7
two claws
2
five screws
(+BTP
2
u6)
4
1
CN5301 (2P)
6
P-SW board
8
KEY-SW board
escutcheon (DSZ)
Click on the first or last page to see other HBD-DZ330 / HBD-DZ710 / HBD-DZ730 service manuals if exist.