Sony DVP-NC85H / HT-7000DH Service Manual ▷ View online
2-5
DVP-NC85H
2-8. LOADING MOTOR ASS’Y
Loading Motor Assembly
(M901)
(M901)
Table
Belt (Timing)
Screw
(M2.6x4) (3CR)
(M2.6x4) (3CR)
Screw
(M2.6x4) (3CR)
(M2.6x4) (3CR)
Claws
Claw
MD-105 Board
ML-068 Harness
(CN004, 2P)
(CN004, 2P)
2-6
DVP-NC85H
2-9. OPTICAL PICK-UP
(DEVICE, OPTICAL KHM-313CAB/C2RP)
Caution Point on the Laser Diode:
Laser Diode in the optical Device is very sensitive to Surge Current or
ElectroStatic Discharge (ESD):
Laser Diode in the optical Device is very sensitive to Surge Current or
ElectroStatic Discharge (ESD):
After take-out FMO-011 Flat Flexible Cable from CN101 of
MV-49 board immediately ground FMO-011 Flat Flexible Cable
pattern using short clip. Metal paper clip can be used as short
clip.
MV-49 board immediately ground FMO-011 Flat Flexible Cable
pattern using short clip. Metal paper clip can be used as short
clip.
Shortland Position
Note:
Solder shortland before remove the
FMO-011 Flat Flaxible Cable from
24 pin BU connector.
FMO-011 Flat Flaxible Cable from
24 pin BU connector.
5
FMO-011 Flat Flexible Cable
(CN101,
24P)
6
Optical Pick-Up
3
Four Insulator Screws
4
MD-112 Harness
(CN201,
6P)
2
FFC Holder
1
FFC Clamp
Caution Point on the Laser Diode Hardness:
Please make sure MD112 Harness (black tapping) always before
hook during assembly. Refer to Fig. 1.
Please make sure MD112 Harness (black tapping) always before
hook during assembly. Refer to Fig. 1.
Black Tapping
Hook
Fig. 1.
2-7
DVP-NC85H
2-10. POWER BLOCK
3
Two Screws
+BV3(3-CR)
5
Two Claws
4
Holder, PS
6
Power Block
2
PM-132 Harness
(CN201,
10P)
1
Power Cord
2-11. FR-251 AND SW-477 BOARDS
Front panel
1
Six Screws +BVTP 2.6 (3CR)
2
FIS-004 Flat Flexible Cable
(CN407,
9P)
5
SW-477 Board
4
FR-251 Board
3
2-8
DVP-NC85H
2-12. INTERNAL VIEWS
BOTTOM VIEW
TOP VIEW
Click on the first or last page to see other DVP-NC85H / HT-7000DH service manuals if exist.