Sony DAV-DZ810W / HCD-DZ810W Service Manual ▷ View online
6
HCD-DZ810W
Fix the capacitors with adhesive agent as follows
Fixing the capacitors with adhesive agent is required by the safety regulation.
Be sure to fix the capacitors with adhesive agent when part or circuit board is replaced.
Be sure to fix the capacitors with adhesive agent when part or circuit board is replaced.
POWER BOARD
C910
C924
IC921
C930
PRECAUTION WHEN INSTALLING A NEW OP UNIT /
PRECAUTION BEFORE UNSOLDERING THE STATIC ELECTRICITY
PREVENTION SOLDER BRIDGE
PRECAUTION BEFORE UNSOLDERING THE STATIC ELECTRICITY
PREVENTION SOLDER BRIDGE
When installing a new OP unit, be sure to connect the flexible printed circuit board first of all before removing the static
electricity prevention solder bridge by unsoldering. Remove the static electricity prevention solder bridge by unsoldering
after the flexible printed circuit board has already been connected.
(Do not remove nor unsolder the solder bridge as long as the OP unit is kept standalone.)
electricity prevention solder bridge by unsoldering. Remove the static electricity prevention solder bridge by unsoldering
after the flexible printed circuit board has already been connected.
(Do not remove nor unsolder the solder bridge as long as the OP unit is kept standalone.)
7
HCD-DZ810W
JACK board
BUTTON BASE
(PLAY)
(PLAY)
CAP (POWER)
wire (flat type)
13core (CNP802)
13core (CNP802)
connector (CNP801)
six screws (+BVTP 2.6)
two screws
(+BVTP 2.6)
(+BVTP 2.6)
BUTTON BASE (POWER)
SW board
CAP (PLAY)
CAP (AMS)
CAP (FUNC)
Precaution when replacing the CAP
Please apply the adhesive agent to the BUTTON BASE (PLAY) when replacing the CAP (PLAY) or CAP (FUNC) or CAP (AMS).
Please apply the adhesive agent to the BUTTON BASE (POWER) when replacing the CAP (POWER).
Please apply the adhesive agent to the BUTTON BASE (POWER) when replacing the CAP (POWER).
8
HCD-DZ810W
MAIN BOARD
POWER BOARD
Precaution on the connector processing of the POWER board.
AC IN
1
3
(Parts face side)
(Parts face side)
CN3002
CN3001
CN902
CN901
When re-assembling, leave 30 mm between
harnesses A and B for safety.
harnesses A and B for safety.
harnesses A
harnesses B
clamp
30mm
9
HCD-DZ810W
• MAIN board service position
• DMB12 board service position
I/O SCART board
DIAT-TX board
DMB12 board
MAIN board
CN701
CN651
Extension cable
J-2501-242-A
(1mm/11pin/L300)
J-2501-242-A
(1mm/11pin/L300)
Extension cable
J-2501-242-A
(1mm/11pin/L300)
J-2501-242-A
(1mm/11pin/L300)
CN4501
CN801
insulation sheet
Extension cable
J-2501-242-A
(1mm/11pin/L300)
J-2501-242-A
(1mm/11pin/L300)
DMB12 board
MAIN board
CN4501
CN701
Click on the first or last page to see other DAV-DZ810W / HCD-DZ810W service manuals if exist.