Sony BDV-NF620 / BDV-NF720 / SS-TSB115 / SS-TSB116 Service Manual ▷ View online
SERVICE MANUAL
Sony Corporation
Published by Sony Techno Create Corporation
SS-TSB115/TSB116
SPECIFICATIONS
SPEAKER SYSTEM
9-893-452-02
2012G33-1
©
2012.07
AEP Model
SS-TSB115/TSB116
UK Model
Taiwan Model
SS-TSB116
Mexican Model
SS-TSB115
Ver. 1.1 2012.07
• SS-TSB115 is Front speaker in BDV-NF620
• SS-TSB116 is Front speaker in BDV-NF720
• SS-TSB116 is Front speaker in BDV-NF720
Photo: SS-TSB115
Photo: SS-TSB116
SS-TSB116
Dimensions (approx.)
100 mm × 430 mm × 35
mm (w/h/d) (wall-mounted
part)
111 mm × 442 mm × 112
mm (w/h/d) (whole
speaker)
mm (w/h/d) (wall-mounted
part)
111 mm × 442 mm × 112
mm (w/h/d) (whole
speaker)
Mass (approx.)
1.0 kg (wall-mounted part)
1.1 kg (whole speaker)
1.1 kg (whole speaker)
SS-TSB115
Dimensions (approx.)
100 mm × 360 mm × 36
mm (w/h/d) (wall-mounted
part)
102 mm × 372 mm × 98
mm (w/h/d) (whole
speaker)
mm (w/h/d) (wall-mounted
part)
102 mm × 372 mm × 98
mm (w/h/d) (whole
speaker)
Mass (approx.)
0.8 kg (wall-mounted part)
0.9 kg (whole speaker)
0.9 kg (whole speaker)
Design and specifications are subject to change
without notice.
without notice.
SS-TSB115/TSB116
2
SECTION 1
DISASSEMBLY
• This set can be disassembled in the order shown below.
1-1. DISASSEMBLY FLOW
1-2. SPEAKER CABINET (NX-FS) BLOCK
(Page
(Page
3)
SET
1-3. MOUNTED
BOARD
(NETWORK)
(MT1)
(Page
3)
1-6. SPEAKER
TERMINAL
(TM1)
(Page
(Page
6)
1-4. LOUDSPEAKER
(18 mm) (SP2)
(Page
4)
1-5. LOUDSPEAKER
(8 cm) (SP1)
(Page
5)
1-8. MOUNTED
BOARD
(NETWORK)
(MT2)
(Page
7)
1-11. SPEAKER TERMINAL
(TM2)
(Page
(TM2)
(Page
10)
1-9. LOUDSPEAKER
(18 mm) (SP4)
(Page
8)
1-10. LOUDSPEAKER
(8 cm) (SP3)
(Page
9)
1-12. FRONT PANEL
(NX-FH)
(Page
(NX-FH)
(Page
11)
1-7. SPEAKER CABINET (NX-FH) BLOCK
(Page
(Page
7)
SET
6676%
6676%
SS-TSB115/TSB116
3
Note: Follow the disassembly procedure in the numerical order given.
1-2. SPEAKER CABINET (NX-FS) BLOCK (SS-TSB115)
1-3. MOUNTED BOARD (NETWORK) (MT1) (SS-TSB115)
2
four screws
(3.5)
2
two screws
(3.5)
2
four screws (3.5)
– Rear bottom view –
Note: Please spread a sheet under a unit
not to injure front panel (NX-FS).
7
speaker cabinet
(NX-FS)
block
5
Open the speaker
cabinet
block.
3
Remove the speaker cabinet (NX-FS) block
in the direction of an arrow.
4 claw
4 claw
1
Use previous thin tweezers etc.
and remove four screw hole covers
not to damage the speaker cabinet.
tweezers etc.
1
Use previous thin tweezers etc.
and remove four screw hole covers
not to damage the speaker cabinet.
tweezers etc.
6 terminal (big)
6 terminal (small)
2
screw (3.5)
3
4
mounted board
(NETWORK)
(MT1)
– Front panel block inner view –
Note: Please spread a sheet under a unit
not to injure front panel (NX-FS).
1 terminal (big)
1 terminal (big)
1 terminal (small)
1 terminal (small)
SS-TSB115/TSB116
4
1-4. LOUDSPEAKER (18 mm) (SP2) (SS-TSB115)
2
screw (3.5)
ditch
ditch
2
screw (3.5)
1 terminal (big)
1 terminal (small)
3
Note: Please spread a sheet under a unit
not to injure front panel (NX-FS).
ditch
ditch
4
loudspeaker (18 mm) (SP2)
wire from
loudspeaker (18 mm)
loudspeaker (18 mm)
wire from loudspeaker (8 cm)
under the loudspeaker (8 cm)
under the loudspeaker (8 cm)
wire from loudspeaker (18 mm)
under the loudspeaker (8 cm)
under the loudspeaker (8 cm)
terminal (small)
From loudspeaker (18 mm)
From loudspeaker (18 mm)
terminal (small)
From loudspeaker (8 cm)
From loudspeaker (8 cm)
terminal (big)
From loudspeaker (8 cm)
From loudspeaker (8 cm)
terminal (big)
From loudspeaker (18 mm)
From loudspeaker (18 mm)
This side must be facing out side.
:LUHVHWWLQJ
mounted board (NETWORK)
mounted board
(NETWORK)
(NETWORK)
mounted board
(NETWORK)
(NETWORK)
loudspeaker (18 mm)
loudspeaker (8 cm)
–)URQWSDQHOEORFNLQQHUYLHZ–
–)URQWSDQHOEORFNLQQHUYLHZ–