View Sharp VC-MH732HM (serv.man31) Technical Bulletin online
blank, i.e. it contains no data. Depending upon the model type, the EEPROM will have to be
programmed with different data as follows:
locations can only be set to either a ‘1’ or a ‘0’. As the values contained within the EEPROM
varies between units, a table is provided in the relevant service manual, detailing model
types and JP data.
2. Connect a shorting link between the pins on test point P802 (see location diagram). When
the VCR. Note that the channel change buttons on the remote control will have no effect.
the data table, the row at the bottom indicates a checksum, which can be used for this purpose. As
this is a ten-figure number it cannot be displayed all at the same time, therefore it has to be done in
2. Press the CHANNEL (+) or CHANNEL (-) buttons until the tape speed indicator is lit (either
represents luminance preset number, the second, the chrominance preset level. See below