DOWNLOAD Sharp LC-M3700 (serv.man30) Service Manual ↓ Size: 4.29 MB | Pages: 72 in PDF or view online for FREE

MENU

ENTER

UP

RIGHT

LEFT

DOWN

INPUT

VOL

Numbers within          refer to the main page(s) where the topic is explained.

Liquid Crystal Display panel

Side control panel
(See below.)

Remote
control sensor

*

When using the 

remote control, point 
it towards here.

STANDBY/ON
button

STANDBY/ON
indicator

Panel side

28

9

28

MENU

ENTER

VOL +/–

UP

LEFT

RIGHT

DOWN

INPUT

30

29

29

Cursor
control

LC-3700

LC-3710

About LC-M3710:
»

The SHARP logo for the LC-M3710 model is 
on the vertical base.

1. Hold down the two claws at the top of the terminal

cover, and pull the cover toward you so it opens a
little.

2. Slowly lift the cover so the three claws at the bottom

come loose from the claw holes in the console.

2

1

3

Built-in monitor
speaker

55

SPEAKER (R)
External speaker terminal
(right)

16

POWER····················
Main power on/off
switch

28

SPEAKER (L)
External speaker terminal
(left)

16

AC Input
terminal···············

17

INPUT2 (INPUT/
OUTPUT)

12

VIDEO OUTPUT

15

RS-232C INPUT··············

15

RS-232C OUTPUT········

15

13

INPUT1

11

15

PC (DIGITAL) INPUT

14

INPUT3/PC (ANALOG)
OUTPUT············

INPUT3

PC (ANALOG)
INPUT··················

14

Removing the terminal cover

Lower claw

Upper claw

INPUT

RETURN

MENU

STANDBY/ON

ENLARGE

WIDE

LCD MONITOR

ENTER

VOL

Numbers within          refer to the main page(s) where the topic is explained.

Signal transmitter

STANDBY/ON

MENU····································

VOL +/– ··································

28

ENLARGE

29

INPUT

29

RETURN

30

30

WIDE·····································

29

Cursor control ('/"/\/|)············

30

ENTER··································

30

29

» Do not expose the remote control unit to shock. In addition, do not

expose the remote control unit to liquids, and do not place it in an
area with high humidity.

» The remote control unit may not work properly if the remote control

sensor is under direct sunlight or strong lighting.
In such cases, change the angle of the lighting or the monitor, or
operate the remote control unit closer to the remote control sensor.

Improper use of batteries can result in chemical leakage
or explosion. Be sure to follow the instructions below.

» Do not mix old and new batteries, or batteries of different

types.

» Do not charge or disassemble batteries.
» Place batteries with their terminals corresponding to the

± and — as indicated in the compartment.

» Do not short-circuit the batteries.

Caution

» The batteries supplied with this product may

have a shorter life expectancy due to storage
conditions. Replace with new batteries at the
earliest opportunity.

» If you will not use the remote control for a long

time, remove its batteries.

» If the remote control does not work, even with

new batteries, take the batteries out, check
whether they are facing the right way, then
replace them.

» Objects between the remote control unit and the remote

control sensor may prevent proper operation.

» Replace the batteries when they run low as this may shorten

the remote control operation range.

10

°

10

°

6 m

7 m

6 m

Remote
control sensor

Gently hold down and
press in the arrow
direction.