Sharp LC-46XD1E (serv.man5) Service Manual ▷ View online
LC-46/52XD1E-RU
5 – 3
Download
6. Connect to the LCD TV and start up "starter298" software.
7. After turn on the power of set, please push the below connect but-
ton.
NOTE: If set power was turned off and on with this condition, strange
character will be appear, so if this strange character appear,
please ignore.
please ignore.
8.
9.
in capital letters
in capital letters
Input "USEROFF" command (non-visited) and return key on your
˴˴˴˴˴˴˴˴˴˴PC. (get "OK"message)
˴˴˴˴˴˴˴˴˴˴PC. (get "OK"message)
Input "DPON" command and return key on your PC. (get "MSH>"
message)
message)
in small letters
Input "fpga 3 0x80" command and return key on your PC, and the
LCD TV is turned off automatically.
LC-46/52XD1E-RU
5 – 4
10.Change the port settings.
11.Connect to the LCD TV by activating the connection button.
12.[Programming]-[Download] Download window will be opened.
setting "115200"
LC-46/52XD1E-RU
5 – 5
13.Select the file which you want to upload.
14.Click "Flash" button and get executed.
click once
click once
LC-46/52XD1E-RU
5 – 6
15.If the Flash has burned successfully, "OK" message is shown as
below.
16.Turn the AC power off , and turn AC power on.
Return to default automatically.
17.Finish!!
18.Prepare for next model
If you have once write the software to the set, the PC side commu-
nication speed will be set up to "115200".
nication speed will be set up to "115200".
So before you connect the PC to the next set, please change back
this speed to "9600".
this speed to "9600".
(Please refer 4-(i)-2)
19.Software writing time
It takes about 15 minutes to write the all software with above
method.
method.
Please keep the cable connection during the PC and Set having a
communication.
communication.
3. Entering and exiting the adjustment process mode
1
Press the "POWER"key on the set
of running TV set to force off the power.
2 While holding
down the “VOL
(-)”and”
MENU
” keys on the set at once,
Press the "POWER"key on the se
t
to turn on the power. The letter
appears on the screen.
3 Next, hold down the “VOL(-)”and
㵘”P( )” keys on the set at once.
Multiple lines of orange characters appearing on the screen indicate that the set is now in the
adjustment Process mode. If you fail to enter the adjustment process mode (the display is the same as
normal startup), retry the procedure.
adjustment Process mode. If you fail to enter the adjustment process mode (the display is the same as
normal startup), retry the procedure.
4 To exit the adjustment process mode after the adjustment is done, unplug the AC power cord to force off
the power. (When the power is turned off with the remote controller, once unplug the AC power cord and
plug it in again. In this case, wait 10 seconds or so before plugging.)
plug it in again. In this case, wait 10 seconds or so before plugging.)
5
To remove "K" mode, just repeat step1 and 2. This time the letter "K" disappears from screen.
Caution: Use due care in handling the information described here lest the users should
know how to enter the adjustment process mode. If the settings are tampered
with in this mode, unrecoverable system damage may result.
with in this mode, unrecoverable system damage may result.
K