Sharp LC-42LE40E Service Manual ▷ View online
LC-32LE40E-LC-42LE40E
45
No picture on the display (1)
↓
The picture doesn't appear in all modes.
MAIN UNIT:
↓
↓YES
↓YES
PANEL_UNIT:
↓YES
↓YES
No picture on the display (2)
↓
Does not the picture come out when TV is received?
TERMINAL UNIT:
↓
↓YES
MAIN_UNIT:
↓YES
↓YES
Is LCD controller's control signal normal?
Check the line between IC U401 and CN409, CN408.
NO
Control signals BRIGHT_ADJ, INVERTER_ON_OFF,
PANEL_VCC_ON/OFF, and it peels off and whether normality is
checked.
PANEL_VCC_ON/OFF, and it peels off and whether normality is
checked.
Check the panel module.
Similarly, is the LVDS signal input to connector of the panel
module?
module?
NO
Wire harness is checked. (Main board to Panel module)
Is LVDS signal output from 1st_channel and 2nd_channel of IC
U401 in each mode?
U401 in each mode?
Check IC U401 and its peripheral control circuits.
Is DIF signal output from pin (13), (14) of TUNER (TU101) to pin
(184), (185) of IC U401?
(184), (185) of IC U401?
Is the voltages of regulation for a TUNER circuit and the power
supply terminal of IC U401 supplied?
supply terminal of IC U401 supplied?
NO
Each power supply circuit is checked.
NO
Check the tuner, IC U401 and their peripheral circuits. Replace
as required.
as required.
Refer to “The picture doesn't appear in all modes.”
Is the above-mentioned LVDS signals output to connector
CN409(for32″), CN408(for 42″)?
CN409(for32″), CN408(for 42″)?
NO
NO
Do X4150 (27MHz) oscillate?
NO
Check X4150 and its peripheral circuits.
LC-32LE40E-LC-42LE40E
46
No picture on the display (3)
↓
Does not the picture come out when TV is received?
TERMINAL UNIT:
↓
MAIN_UNIT:
↓YES
↓YES
↓YES
↓YES
<External input (SCART)>No picture on the display (4)
↓
Does not the picture of the CVBS signal input to SCART go out?
TERMINAL_UNIT:
↓
MAIN_UNIT:
↓YES
↓YES
<External input (SCART)>No picture on the display (5)
↓
Does not the picture of the R/G/B video signal input to SCART go out?
TERMINAL_UNIT:
↓
MAIN_UNIT:
↓YES
↓YES
Is DIF signal output from pin (13), (14) of TUNER (TU101) to pin
(35), (36) of IC U1011?
(35), (36) of IC U1011?
Is the voltage of regulation for a TUNER circuit and the power
supply terminal of IC U401 supplied?
supply terminal of IC U401 supplied?
NO
Each power supply circuit is checked.
NO
Check the tuner, IC U1011 and their peripheral circuits. Replace
as required.
as required.
NO
Are MPEG data (DEMOD_TSDATA0, TSSYNC, TSVAL, and TSCLK)
signals from pin (15), (16), (17), (18) of IC U1011 output to IC U401?
signals from pin (15), (16), (17), (18) of IC U1011 output to IC U401?
Check MPEG data bus from IC TU1011 to IC U401.
Refer to “The picture doesn't appear in all modes.”
NO
Is CVBS signal sent to pin (20) of SCART (CN151)?
Check the setting of an external input device that connects of
CN151.
CN151.
Is CVBS signal sent to pin (175) of IC U401?
NO
Check the circuit between IC U401 and CN151.
Refer to “The picture doesn't appear in all modes.”
Do X4150 (27MHz) oscillate?
NO
Check X4150 and its peripheral circuits.
NO
Is RGB signal sent to pin (15/11/7) of SCART (CN151)?
Check the setting of an external input device that connects of
CN151.
CN151.
Is RGB signal sent to pin (158/160/161) of IC U401?
NO
Check the line between IC U401 and CN151.
Refer to “The picture doesn't appear in all modes.”
LC-32LE40E-LC-42LE40E
47
<External input (Component)>No picture on the display (6)
↓
Does not the picture of the component video signal input to Component go out?
TERMINAL_UNIT:
↓
MAIN_UNIT:
↓YES
↓YES
<External input AV (Composite)>No picture on the display (7)
↓
Does not the picture of the composite video signal input to AV(Composite) go out?
TERMINAL UNIT:
↓
MAIN_UNIT:
↓YES
↓YES
<External input HDMI1 >No picture on the display (8)
↓
Does not the picture of the HDMI signal input to HDMI1 go out?
MINI AV_UNIT:
↓
↓NO
YES
↓YES
↓YES
↓YES
Is CVBS signal sent to pin (2) of AV (CN136) ?
NO
Check the setting of an external input device that connects of
CN136.
CN136.
Refer to “The picture doesn't appear in all modes.”
Is CVBS signal sent to pin (181) of IC U401?
NO
Check the line between IC U401 and CN136.
Is the HOT_PLUG detection function of pin (19) of a HDMI terminal
(CN502) normal?
(CN502) normal?
NO
Check the line between pin (50) of IC U501 and CN502.
Refer to “The picture doesn't appear in all modes.”
Check the connection and setup with the external HDMI devices.
Are EDID data pin (6) (SCL) of IC U503 (EEPROM), pin (5) (SDA)
accessed, and is it read from pin (15), pin (16) of a HDMI terminal
(CN502)?
accessed, and is it read from pin (15), pin (16) of a HDMI terminal
(CN502)?
Is access possible in the re-writing or exchange of EDID data of
IC U503?
IC U503?
NO
Is TMDS signal input into pin(63, 62)/RX2-2±,(60, 59)/RX2-1±, (57,
56)/RX2-0±, (54, 53)/RX2-C± of IC U501?
56)/RX2-0±, (54, 53)/RX2-C± of IC U501?
Check the line between IC U501 and CN502.
NO
NO
Is Component Y/Pb/Pr signal sent to pin (2)/Y, (4)/Pb, (6)/Pr of
AV1(CN111) ?
AV1(CN111) ?
Check the setting of an external input device that connects of
CN111.
CN111.
Is Component Y/Pb/Pr signal sent to pin (163/165/166) of IC U401?
NO
Check the line between IC U401 and CN111
Refer to “The picture doesn't appear in all modes.”
Is TMDS signal output from pin(17, 18)/ 2±,(20, 21)/ 1±, (23, 24)/ 0±,
(26, 27)/_C± of IC U501?
(26, 27)/_C± of IC U501?
NO
Check IC U501 and peripheral circuits.
LC-32LE40E-LC-42LE40E
48
<External input HDMI2 >No picture on the display (9)
↓
Does not the picture of the HDMI signal input to HDMI2 go out?
MINI AV_UNIT:
↓
↓NO
YES
↓YES
↓YES
↓YES
<External input VGA>No picture on the display (10)
↓
Does not the picture of the PC IN(ANALOG) video signal input to VGA (15pin-D-SUB terminal) go out?
TERMINAL_UNIT:
↓
MAIN_UNIT:
↓YES
↓YES
Is R/G/B/H/V signal sent to pin (1)/R, (2)/G, (3)/B, (13)/H, (14)/V of
VGA (CN101)?
VGA (CN101)?
NO
Check the setting of an external input device that connects of
CN101.
CN101.
Refer to “The picture doesn't appear in all modes.”
Is R/G/B/H/V signal sent to pin (156)/R, (154)/G, (152)/B, (151)/H,
(150)/V of IC U401?
(150)/V of IC U401?
NO
Check the line between IC U401 and CN101.
Is the HOT_PLUG detection function of pin (19) of a HDMI terminal
(CN506) normal?
(CN506) normal?
NO
Check the line between pin (35) of IC U501 and CN506.
Refer to “The picture doesn't appear in all modes.”
Check the connection and setup with the external HDMI devices.
Are EDID data pin (6)(SCL) of IC U504 (EEPROM), pin (5)(SDA)
accessed, and is it read from pin (15), pin (16) of a HDMI
terminal(CN506)?
accessed, and is it read from pin (15), pin (16) of a HDMI
terminal(CN506)?
Is access possible in the re-writing or exchange of EDID data of
IC U504?
IC U504?
NO
Is TMDS signal input into pin(48, 47)/RX3-2±,(45, 44)/RX3-1±, (42,
41)/RX3-0±, (39, 38)/RX3-C± of IC U501?
41)/RX3-0±, (39, 38)/RX3-C± of IC U501?
Check the line between IC U501 and CN506.
NO
Is TMDS signal output from pin(17, 18)/ 2±,(20, 21)/ 1±, (23, 24)/ 0±,
(26, 27)/_C± of IC U501?
(26, 27)/_C± of IC U501?
NO
Check IC U501 and peripheral circuits.
Click on the first or last page to see other LC-42LE40E service manuals if exist.