Sharp LC-40LE600E (serv.man18) Service Manual / Technical Bulletin ▷ View online
LCD 2010 06 07
Date of Issue:
25
th
June 2010
Classification:
White
LCD TELEVISION TECHNICAL BULLETIN
Page 1 of 3
Sharp Electronics (UK) Limited
Reference – JW20100526
Revision - 1
White – Carry out as required
Yellow – Carry out as required and whenever the unit comes in for service
Red – Carry out on all units
MODELS
LC32LE600E LC40LE600E LC46LE600E
SYMPTOM Stuck in stand by following software update or PWB replacement the Red LED
flashing, if there has been more than 5 attempts to bring the TV on with the incorrect
settings then the TV will be none responsive and show only the Red power LED.
settings then the TV will be none responsive and show only the Red power LED.
CAUSE
Incorrect MODEL NAME / INCH SIZE identification within the service menu setup
software resulting in “Lamp error” protection mode “STANDBY CAUSE” (1B).
software resulting in “Lamp error” protection mode “STANDBY CAUSE” (1B).
ACTION
Follow the instructions given below to gain access to the engineer “service menu” and
check/reset “INCH SIZE” and “MODEL NAME” where applicable.
Switch the TV off using the rocker switch located on the lower left side of the TV (just
around the back).
around the back).
Whilst hold down the “Input” button and “Volume –“ buttons on the set, switch the TV on
again using the rocker switch left side.
again using the rocker switch left side.
After 30 seconds the set should function showing a [K] in the upper left part of the
screen.
screen.
Press together the Volume – and Program – buttons on the set.
You should now be in the engineer service menu (see Figure 1).
Using the Channel up and Down buttons on the remote to select the “INCH SIZE” then
“MODEL NAME” and correct using the Right arrow or Volume + - button to the details as
indicated on the cabinet back (see Figures 2 and 3).
Reset “STANBY CAUSE” as required, change “ERROR RESET” to “YES” and press
“OK”.
“MODEL NAME” and correct using the Right arrow or Volume + - button to the details as
indicated on the cabinet back (see Figures 2 and 3).
Reset “STANBY CAUSE” as required, change “ERROR RESET” to “YES” and press
“OK”.
Do not make any other adjustments within any other part of the service menus
as this can result in unrecoverable errors.
When completed switch off and remove the mains supply.
LCD 2010 06 07
Date of Issue:
25
th
June 2010
Classification:
White
LCD TELEVISION TECHNICAL BULLETIN
Page 2 of 3
Sharp Electronics (UK) Limited
Reference – JW20100526
Revision - 1
White – Carry out as required
Yellow – Carry out as required and whenever the unit comes in for service
Red – Carry out on all units
Figure 1: Service menu showing screen size and Model name.
Figure 2:
Service menu indications of Model versions selection E, E(A), E(B) or E(C).
LCD 2010 06 07
Date of Issue:
25
th
June 2010
Classification:
White
LCD TELEVISION TECHNICAL BULLETIN
Page 3 of 3
Sharp Electronics (UK) Limited
Reference – JW20100526
Revision - 1
White – Carry out as required
Yellow – Carry out as required and whenever the unit comes in for service
Red – Carry out on all units
Figure 3:
The Model number may be followed by a box containing the Variant letter, the above
label shows the [A] variant which must be set in the service mode detailed above along with the
46” in the “INCH SIZE”.
.
Display