Sharp LC-40LE361E Service Manual ▷ View online
9
LC-32/40LE361
LC-32/40LE360
LC-32/40LE362
LC-32/40LE363
OPERATION MANUAL - Continued
English - 6 -
Environmental Information
This television is designed to consume less energy
to help save the environment. To reduce energy
consumption, you should take the following steps:
You can use
You can use
Power Save Mode setting, located
in the
Picture menu. If you set Power Save Mode
as
Eco, the TV will switch to energy-saving mode
and luminance level of TV set will be decreased to
optimum level. Note that some picture settings will be
unavailable to be changed when the TV is in
Power
Save Mode.
When you press the right button on the remote while
When you press the right button on the remote while
Power Save Mode is set to “ Eco”, “Screen will be
off in 15 seconds.” message will be displayed on
the screen. If the
Power Save Mode option is set to
“
Disabled” press the left button. Select PROCEED
and press
OK to continue. The screen will turn of f
immediately. If you do not press any buttons the
screen will turn off after 15 seconds.
If you disable
If you disable
Power Save Mode, the picture mode
will be automatically set to
Dynamic except the Mode
is set to
Game or Sports.
When the TV is not in use, please switch of f or
disconnect the TV from the mains plug. This will also
reduce energy consumption.
Disconnect power when going away for longer time.
It is highly recommended to activate
Disconnect power when going away for longer time.
It is highly recommended to activate
Power Save Mode
setting to reduce your annual power consumption. And
also it is recommended to disconnect the TV from the
mains plug to save energy more when you do not use.
Please help us to save environment by following
Please help us to save environment by following
these steps.
Package Contents
Remote Control
LCD TV
Batteries: 2 X AAA
Quick Guide
1 X Video & Audio Connection
Cable
Note: You should check the accessories after purchasing.
Make sure that each accessory is included.
As the manufacturer ’s specification supports
communication on cable lengths shall be smaller
than 3m.
TV Control button & Operation
1. Up direction
2. Down direction
3. Volume / Info / Sources List selection and
2. Down direction
3. Volume / Info / Sources List selection and
Standby-On switch
The Control button allows you to control the Volume
/ Programme / Source and Standby-On functions of
the TV.
, switch is used for turning the TV on or off.
The position of the power switch may differ depending
on the model.
A01_[GB]_MB90_4847UK_DVBT2_C_S_3D_PVR_CONNECTIVITY_INTERNALWIFI_OPENBROWSER_DLNA_HBBTV_MMH_ORTAK IB_WEB_REV02.indd 6
01.10.2014 17:58:34
10
LC-32/40LE361
LC-32/40LE360
LC-32/40LE362
LC-32/40LE363
OPERATION MANUAL - Continued
English - 7 -
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable/Satellite Connection
Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT.) or satellite lead to the SA TELLITE
INPUT(LNB) located on the rear side of the TV.
“Satellite is only available in 362/363 series”.
Rear side of the TV:
Rear side of the TV:
SATELLITE
AERIAL
CABLE
Note: Satellite support is depending on the model.
(only available in LC-32LE363EN / LC-32LE362EN
/ LC-40LE363EN / LC-40LE362EN series)
Installing The Batteries Into The
Remote
• Remove the back cover to reveal the battery
compartment.
• Insert two size AAA batteries. Note the correct
polarity(+ or -). Do not mix old and new batteries.
Replace only with same or equivalent type.
• Place the cover back on.
Angle of the remote control unit
Use the remote control unit by pointing it towards the
remote control sensor.
Objects between the remote control unit and sensor
Objects between the remote control unit and sensor
may prevent proper operation.
Cautions regarding the remote control unit
• Do not expose the remote control unit to shock.
In addition, do not expose the remote control unit
to liquids, and do not place in an area with high
humidity.
• Do not install or place the remote control unit under
direct sunlight. The heat may cause deformation
of the unit.
• The remote control unit may not work properly if
the remote control sensor of the TV is under direct
sunlight or strong lighting. In such cases, change the
angle of the lighting or the TV, or operate the remote
control unit closer to the remote control sensor.
Switching On/Off
To Switch the TV On
Connect the power cord to the mains socket. Switch
the “
” button on the TV to position “|” so the TV
will switch to standby mode. Then the standby LED
lights up.
To switch on the TV from standby mode either:
• Press the “ ” button,
To switch on the TV from standby mode either:
• Press the “ ” button,
P+ / P- or a numeric button
on the remote control.
• Press the side function switch on the TV until the TV
comes on from standby.
The TV will then switch on.
To Switch the TV to Standby
To switch the TV to low power standby press the
“ ” button on the remote control or press the side
“ ” button on the remote control or press the side
function switch on the TV until the TV switches into
standby mode.
To Switch the TV Off
Switch the “
” button on bottom of the TV to
position 2 as illustrated - “
”, to isolate the TV from
the mains, the LED will go out.
A01_[GB]_MB90_4847UK_DVBT2_C_S_3D_PVR_CONNECTIVITY_INTERNALWIFI_OPENBROWSER_DLNA_HBBTV_MMH_ORTAK IB_WEB_REV02.indd 7
01.10.2014 17:58:35
11
LC-32/40LE361
LC-32/40LE360
LC-32/40LE362
LC-32/40LE363
[1] DIMENSIONS 32”
NOTE: The Unit of the measurements is mm.
CHAPTER 3. OPERATION MANUAL
English - 30 -
Dimensional Drawings
32281 (LC-32LE36x Series)
40281 (LC-40LE36x Series)
Note: The unit of the measurements is mm.
A01_[GB]_MB90_4847UK_DVBT2_C_S_3D_PVR_CONNECTIVITY_INTERNALWIFI_OPENBROWSER_DLNA_HBBTV_MMH_ORTAK IB_WEB_REV02.indd 30
01.10.2014 17:58:41
12
LC-32/40LE361
LC-32/40LE360
LC-32/40LE362
LC-32/40LE363
NOTE: The Unit of the measurements is mm.
[2] DIMENSIONS 40”
English - 30 -
Dimensional Drawings
32281 (LC-32LE36x Series)
40281 (LC-40LE36x Series)
Note: The unit of the measurements is mm.
A01_[GB]_MB90_4847UK_DVBT2_C_S_3D_PVR_CONNECTIVITY_INTERNALWIFI_OPENBROWSER_DLNA_HBBTV_MMH_ORTAK IB_WEB_REV02.indd 30
01.10.2014 17:58:41
Click on the first or last page to see other LC-40LE361E service manuals if exist.