DOWNLOAD Sharp LC-32SA1E (serv.man2) Service Manual ↓ Size: 39.39 MB | Pages: 127 in PDF or view online for FREE

LC-26SA1E/RU, LC-32SA1E/RU

5 – 5

1) Select:  Serial

→COM X→ O.K.

2) Select:  Terminal

3) Choose the same options as the above picture.

     LC-26SA1E/RU, LC-32SA1E/RU

5 – 6

4) Select:  Setup  

→ Serial port → O.K. Appear the follow screen:

5) Select follows settings:

6) Check the connection between TV set and PC, sending a wrong command, as for example: “aaa”. TV set returns an “err” label as an syntaxes

ERROR (Not correct order or sequence).

Send a “DWMD” (capital letters) command to enter TV set in Download Mode.

Change a baud rate to 115200.

Select:  Setup 

→ Baud rate  → 115200 → O.K.

Serial port to use:

COM x

Baud rate:

9600

Data:

8 bits

Parity:

none

Stop:

1 bit

Flow control:

none

Enter O.K.

LC-26SA1E/RU, LC-32SA1E/RU

5 – 7

7) Select:  File 

→ Transfer → XMODEM → Sent

8) Choose the file for upgrade and click “Open”.

9) After select “Open” the upgrade process starts as follows:

     LC-26SA1E/RU, LC-32SA1E/RU

5 – 8

10)When flash update process finishes, the “Flash programming complete” label appear in the screen , the device automatically go to switch off, and

in a few seconds go to switch on again.

1. A Parallel port I2C interface with 20 pin to 3 pin cable (Sharp Code: CKIT-0004WJV0).

2. Make the connections as indicated below:

i)

Connect Parallel port I2C interface to LPT port of the computer.

ii) Connect the 20 to 3 pin cable from the I2C interface to the P2306 socket in the main board (XD603).

1. Install Visual I2C release V3.2.3b from file (“Setup_Visual_I2C_v3-2-3b8h.exe”).

• It’s strongly recommended to accept the suggested default folder (“C:\Program Files\Micronas\Visual I2C”).

2. Install Visual I2C VCTp extension from file (“Setup_VI2C_for_VCT6wxyP_v0111.exe”).

• It’s interesting to change default folder to same as Visual I2C (“C:\Program Files\Micronas\Visual I2C”).

• During this installation process is possible to install also a complementary software to manage NVM memories .

This installation is not needed, for this reason uncheck the option when the setup program ask to you. In case of installation it’s interesting to change
default folder to same as Visual I2C (“C:\Program Files\Micronas\Visual I2C”).

3. Install Parallel driver depending of your Windows version from existing files inside the Visual I2C installation folder “C:\Program Files\Micro
    nas\Visual I2C\Port_Driver”, following next criteria:.

1) Windows 98/Me (“Setup_LptDrv_v0104_9x.exe”).

2) Windows NT (“Setup_LptDrv_v0104_NT_2000.exe”).

To PC

To P2306

QCNWGA100WJZZ

QPWBX0004WJZZ