Sharp LC-32BT8EA (serv.man6) Service Manual ▷ View online
LC-32GD8EA/RUA, LC-32BT8EA/RUA
3 – 1
LC-32GD8EA/RUA, LC-32BT8EA/RUA
Service Manual
CHAPTER 3.
SCHEMATIC DIAGRAM
[1] DESCRIPTION OF SCHEMATIC DIAGRAM
1. VOLTAGE MEASUREMENT CONDITION:
1) The voltages at test points are measured on exclusive AC adaptor and the stable supply voltage of AC 120V. Signals are fed by a color bar signal
generator for servicing purpose and the above voltages are measured with a 20k ohm/V tester.
2. INDICATION OF RESISTOR & CAPACITOR:
RESISTOR
1) The unit of resistance "
Ω" is omitted.
(K=k
Ω=1000Ω, M=MΩ).
2) All resistors are ± 5%, unless otherwise noted.
(K= ± 10%, F= ± 1%, D= ± 0.5%)
3) All resistors are 1/16W, unless otherwise noted.
CAPACITOR
1) All capacitors are
µF, unless otherwise noted.
(P=pF=
µµF).
2) All capacitors are 50V, unless otherwise noted.
CAUTION:
This circuit diagram is original one, therefore there may be a slight
difference from yours.
This circuit diagram is original one, therefore there may be a slight
difference from yours.
SAFETY NOTES:
1) DISCONNECT THE AC PLUG FROM THE AC OUTLET
1) DISCONNECT THE AC PLUG FROM THE AC OUTLET
BEFORE REPLACING PARTS.
2) SEMICONDUCTOR HEAT SINKS SHOULD BE REGARDED AS
POTENTIAL SHOCK HAZARDS WHEN THE CHASSIS IS
OPERATING.
OPERATING.
IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH "
" (
) ARE IMPORTANT
FOR MAINTAINING THE SAFETY OF THE SET. BE SURE TO
REPLACE THESE PARTS WITH SPECIFIED ONES FOR MAIN-
TAINING THE SAFETY AND PERFORMANCE OF THE SET.
REPLACE THESE PARTS WITH SPECIFIED ONES FOR MAIN-
TAINING THE SAFETY AND PERFORMANCE OF THE SET.
LC-32GD8EA/RUA, LC-32BT8EA/RUA
3 – 2
[2] MAIN Unit
• MAIN Unit-1
A
C
B
D
E
F
G
H
1
2
3
4
5
6
7
8
9
10
LC-32GD8EA/RUA, LC-32BT8EA/RUA
3 – 3
10
11
12
13
14
15
16
17
18
19
LC-32GD8EA/RUA, LC-32BT8EA/RUA
3 – 4
• MAIN Unit-5
A
C
B
D
E
F
G
H
1
2
3
4
5
6
7
8
9
10
Display
