DOWNLOAD Sharp LC-19D1EWH (serv.man10) Service Manual ↓ Size: 1.2 MB | Pages: 32 in PDF or view online for FREE

75.0

(75,0)

49.0

(49,0)

68.2

(68,2)

196.0

(196,0)

2.5˚

(2,5˚)

10.0˚

(10,0˚)

462.0

(462,0)

411.8

(411,8)

360.0

(360,0)

320.0

(320,0)

218.0

(218,0)

40.0

(40,0)

240.0

(240,0)

100.0

(100,0)

100.0

(100,0)

17.5

(17,5)

232.4

(232,4)

[mm]

The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 13A fuse. Should
the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked 

 or 

ASA

 and of the same rating

as above, which is also indicated on the pin face of the plug, must be used.
Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut off the
mains plug and fit an appropriate type.

DANGER:
The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed of
in a safe manner.
Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet, as a serious
electric shock may occur.
To fit an appropriate plug to the mains lead, follow the instructions below:

IMPORTANT:
The wires in the mains lead are coloured in accordance with the following code:

As the colours of the wires in the mains lead of this product may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
• The wire which is coloured blue must be connected to the plug terminal which is marked N or coloured black.
• The wire which is coloured brown must be connected to the plug terminal which is marked L or coloured red.
Ensure that neither the brown nor the blue wire is connected to the earth terminal in your three-pin plug.
Before replacing the plug cover make sure that:
• If the new fitted plug contains a fuse, its value is the same as that removed from the cut-off plug.
• The cord grip is clamped over the sheath of the mains lead, and not simply over the lead wires.
IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

Attaching the stand ……………………………………………

3

Setting the TV …………………………………………………

3

Inserting the batteries …………………………………………

4

Using the remote control unit

………………………………

4

        Cautions regarding the remote control unit …………

4

Remote control unit ……………………………………………

5

TV (Front/Side view)

…………………………………………

6

TV (Rear view) …………………………………………………

6

Turning on the power …………………………………………

7

Standby mode …………………………………………………

7

Turning off the power …………………………………………

7

Initial auto installation (Analogue)

…………………………

7

Initial auto installation (DTV) …………………………………

7

Connecting a VCR ……………………………………………

8

Connecting a game console or camcorder

………………

8

Connecting a DVD player ……………………………………

8

Connecting a decoder ………………………………………

8

Connecting a PC ………………………………………………

9

Common operations …………………………………………

9

AV Mode ……………………………………………………… 10
Picture menu

………………………………………………… 10

OPC ……………………………………………………… 10
Picture adjustments

…………………………………… 10

Advanced ………………………………………………… 10

Audio menu …………………………………………………… 11

Audio adjustments ……………………………………… 11
Sound Wide ……………………………………………… 11

Power Control menu ………………………………………… 12

No Signal Off …………………………………………… 12
No Operation Off ………………………………………… 12
Power Management …………………………………… 12

Setup menu …………………………………………………… 12

Auto Installation ………………………………………… 12
Programme Setup ……………………………………… 12

Auto Search ………………………………………… 13
Manual Adjust ……………………………………… 13
Sort ………………………………………………… 14
Erase Programme ………………………………… 14

       Child Lock ………………………………………………… 14

Input Label ……………………………………………… 14
Position …………………………………………………… 14
PC Setup ………………………………………………… 15
HDMI Audio Select ……………………………………… 15
HDMI Auto View ………………………………………… 15

WSS (Wide Screen Signalling) ………………………… 15
4:3 Mode ………………………………………………… 15
Rotate …………………………………………………… 16
Language ………………………………………………… 16
Supply Voltage

………………………………………… 16

Option menu

………………………………………………… 16

DNR (Digital Noise Reduction) ………………………… 16
Input Select ……………………………………………… 16
Audio Only ……………………………………………… 16
Colour System …………………………………………… 16

WIDE MODE

………………………………………………… 17

Using the analogue programme list ………………………… 17
Freezing the image while watching ………………………… 17
Teletext function ……………………………………………… 18

DTV common operations …………………………………… 18

About using the character set screen ………………… 19

Language ……………………………………………………… 19
Programme Setup …………………………………………… 19
Installation

…………………………………………………… 20

Auto Installation ………………………………………… 20
Carrier Scan ……………………………………………… 20
Carrier Setup …………………………………………… 21

System Setup ………………………………………………… 21

OSD Setup ……………………………………………… 21
Child Lock

……………………………………………… 21

Accessories …………………………………………………… 22

Version (Software version) ……………………………… 22
Software Upgrade ……………………………………… 22

Common Interface …………………………………………… 22

Inserting a CA card

…………………………………… 22

About EPG

…………………………………………………… 23

Using the EPG …………………………………………… 23
Using the EPG Timer …………………………………… 23

Using the ESG ………………………………………………… 23
Using the digital programme list …………………………… 24
Displaying subtitles …………………………………………… 24
Viewing a service banner …………………………………… 24
Using the multi audio function ……………………………… 24
Using the MHEG5 application (UK only) …………………… 24

Troubleshooting ……………………………………………… 25
RS-232C port specifications ………………………………… 26
Specifications ………………………………………………… 27
PC compatibility chart (EXT 5 only) ………………………… 27

• The illustrations and the OSD (On-Screen Display) in this operation manual are for explanation purposes and may vary

slightly from the actual operations.

• The marks (-BK, -WH and etc.) at the end of model name represent the colour of the TV cabinet.

ENGLISH

: these icons used throughout this manual indicate the menu item can be set or adjusted

only in the selected input mode.

• “PC only” refers to the PC input EXT 5 terminal and does not include PC input (HDMI-

PC input) on the EXT 4 (HDMI) terminal.

• HDMI-PC: PC (RGB) input on the EXT 4 (HDMI) terminal
• The HDMI-PC input is compatible with VGA.

• “HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI

Licensing LLC.”

• The “HD ready” Logo is a trademark of EICTA.

• The DVB logo is the registered trademark of the Digital Video Broadcasting - DVB - project.

• Cleaning—Unplug the AC cord from the AC outlet before cleaning the product. Use a damp cloth to clean the

product. Do not use liquid cleaners or aerosol cleaners.

• Water and moisture—Do not use the product near water, such as bathtub, washbasin, kitchen sink, laundry tub,

swimming pool and in a wet basement.

• Do not place vases or any other water-filled containers on this product.

The water may spill onto the product causing fire or electric shock.

• Stand—Do not place the product on an unstable cart, stand, tripod or table. Doing so can

cause the product to fall, resulting in serious personal injuries as well as damage to the product.
Use only a cart, stand, tripod, bracket or table recommended by the manufacturer or sold with
the product. When mounting the product on a wall, be sure to follow the manufacturer’s
instructions. Use only the mounting hardware recommended by the manufacturer.

• When relocating the product placed on a cart, it must be moved with utmost care. Sudden

stops, excessive force and uneven floor surface can cause the product to fall from the cart.

• Ventilation—The vents and other openings in the cabinet are designed for ventilation. Do not

cover or block these vents and openings since insufficient ventilation can cause overheating
and/or shorten the life of the product. Do not place the product on a bed, sofa, rug or other
similar surface, since they can block ventilation openings. This product is not designed for built-
in installation; do not place the product in an enclosed place such as a bookcase or rack, unless
proper ventilation is provided or the manufacturer’s instructions are followed.

• The LCD panel used in this product is made of glass. Therefore, it can break when the product is dropped or

impact applied. If the LCD panel is broken, be careful not to be injured by broken glass.

• Heat sources—Keep the product away from heat sources such as radiators, heaters, stoves and other heat-

generating products (including amplifiers).

• To prevent fire, never place any type of candle or naked flames on the top or near the TV set.
• To prevent fire or shock hazard, do not place the AC cord under the TV set or other heavy items.
• Do not display a still picture for a long time, as this could cause an afterimage to remain.
• There is power consumption always if main plug is connected.
• Servicing—Do not attempt to service the product yourself. Removing covers can expose you to

high voltage and other dangerous conditions. Request a qualified person to perform servicing.

The LCD panel is a very high technology product, giving you fine picture details.
Due to the very large number of pixels, occasionally a few non-active pixels may appear on the screen as
a fixed point of blue, green or red.
This is within product specifications and does not constitute a fault.

When moving the TV, it should always be carried by two people, using both hands, be careful not to apply
pressure to the display.

Thank you for your purchase of the SHARP LCD colour TV product. To ensure safety and many years of trouble-
free operation of your product, please read the Important Safety Precautions carefully before using this product.

Remote control unit (g1)

Pages 4 and 5

• “AA” size battery (g2)...........Page 4

Product shape varies in some countries.

Stand unit (g1)

Page 3

Cable clamp (g1)

Page 3

AC cord (g1)

Page 3

• Operation manual (This publication)

Before attaching (or detaching) stand, unplug the AC cord from the AC INPUT terminal.

Confirm the 3 screws supplied with the TV.

Screws (m3)

(used in step 3)

Insert the stand into the opening on the bottom of
the TV. (1)

Insert and tighten the 3 screws on the bottom of
the TV as shown. (2)

• To detach the stand, perform the above steps in reverse order.

Alignment protrusions

Soft cushion

Screw

Hex key

Standard DIN45325 plug
(IEC 169-2)
75-ohm coaxial cable

Connect the antenna cable from your antenna-/cable socket or the (room-/roof) antenna for antenna input terminal on
the back of your TV set to receive digitally/terrestrially broadcast stations.
An indoor antenna can also be used under good reception conditions. Passive and active room antennas are offered
commercially. In an active antenna its power is supplied via the antenna input terminal.
The supply voltage (5V) must be correspondingly set under “Supply Voltage”. (Page 16)

The Ferrite Core should be permanently attached and never removed from the AC cord.
The AC cord is supplied either with a ferrite core or without a ferrite core. Neither type causes unnecessary electrical
wave emissions or interference.

AC cord

Place the TV close to the AC
outlet, and keep the power plug
within reach.

Cable clamp

Ferrite Core*

Product shape varies in some
countries.