DOWNLOAD Sharp LC-15SH1E (serv.man9) Service Manual ↓ Size: 795.07 KB | Pages: 9 in PDF or view online for FREE

Model
LC-15SH1E (serv.man9)
Pages
9
Size
795.07 KB
Type
PDF
Document
Service Manual
Brand
Device
TV / LCD / (7)Adjustment Procedure
File
lc-15sh1e-sm9.pdf
Date

Sharp LC-15SH1E (serv.man9) Service Manual ▷ View online

16
LC-13SH1E
LC-15SH1E
9. Software  Loading
1) Upgrading the software or after replacement of IC151, IC501 or Main PWB, make sure to upload the processors
with updated software.
2) Please use the dedicated Interface JIG (JIGINF-001) and supplied programs for upgrading the software.
3) This model employs two software;
 SCALER microprocessor software
 MAIN microprocessor software
Please upload the SCALER microprocessor software first follow by MAIN microprocessor software.
1. SCALER microprocessor
1) Set Interface JIG switch to position "SCALER".
2) Power ON the set and plug Interface JIG connector to P2002.
3) Run the ISP_Tool.exe program.
17
LC-13SH1E
LC-15SH1E
4) First click [SST / ATMEL] and then follow by [Identify] to identify the flash memory.
Confirm the item below in Comment Window.
5) Click [Select Intel HEX File …] to open the source files. The source file name are "Sedna_Sharp****.hex"
Confirm the source file is loaded correctly.
6) Next click the [Erase] to erase all the data in the flash memory. Confirm the erase process is complete
without any error.
7) Then click [Program] to start uploading the source file into the flash memory. After uploading process is
complete, confirm there are no error.
8) Click [Verify] to verify the uploaded data and confirm there are no error.
18
LC-13SH1E
LC-15SH1E
9) Finally click [Restart System] to initialize. Confirm "Reset done" in Comment Window.
10) Power OFF the set by unplugging AC Cord, remove the JIG from the plug and wait for 1 minute before
power ON again.
Notes: If any error occur during any process, power OFF the set and repeat the all the process again. If
these still fail, please erase Main Software and repeat the whole process again. To erase Main software,
please refer to MAIN microprocessor step No. 1) to 5) only.
2. MAIN microprocessor
1) Set JIG switch to position "LOC".
2) Power ON the set and plug Interface JIG connector to P2002.
3) Run the WISP.exe program.
19
LC-13SH1E
LC-15SH1E
4) First click [Enter ISP Mode] then click [Send]. If the following window appear, click [Yes]
Confirm ISP status "Ready".
If "Entering ISP is not successful" occur, repeat step No. 4) again. If still fail, unplug the AC cord and
repeat from step No. 2) again.
5) Then click [Erase Flash], follow by [Send]. Confirm the Program, PK26 & Character are all "OK" and ISP
status is "Ready".
If "Failed" occur, unplug the AC cord and repeat the whole process again from beginning.
Page of 9
Display

Click on the first or last page to see other LC-15SH1E (serv.man9) service manuals if exist.