DOWNLOAD Sharp XR-20S Service Manual ↓ Size: 1.16 MB | Pages: 42 in PDF or view online for FREE

13

• 

Plug the power cord into the AC socket of the
projector.

• 

While pressing simultaneously “DOWN”,
“MENU” and “ENTER” on the projector, press
“ON”.

• 

“LAMP 0000H” is displayed, indicating that the
lamp timer is reset.

 

• 

Make sure to reset the lamp timer only when
replacing the lamp. If you reset the lamp timer
and continue to use the same lamp, this may
cause the lamp to become damaged or
explode.

14

• 

 Be sure to unplug the power cord before
cleaning the projector.

• 

The cabinet as well as the operation panel is
made of plastic. Avoid using benzene or thinner,
as these can damage the finish on the cabinet.

• 

Do not use volatile agents such as insecticides
on the projector.
Do not attach rubber or plastic items on the
projector for long time.
The effects of some of the agents in the plastic
may cause damage to the quality or finish of the
projector.

 

• 

Wipe off dirt gently with a soft flannel cloth.

 

• 

When the dirt is hard to remove, soak a cloth in
a neutral detergent diluted with water, wring the
cloth well and then wipe the projector.
Strong cleaning detergents may discolour, warp
or damage the coating on the projector.
Make sure to test on a small, inconspicuous
area on the projector before using.

• 

Use a commercially available blower or lens cleaning
paper (for glasses and camera lenses) for cleaning
the lens. Do not use any liquid type-cleaning agents,
as they may wear off the coating film on the surface
of the lens.

 

• 

As the surface of the lens can easily get damaged,
be sure not to scrape or hit the lens.

• 

Use a vacuum cleaner to clean dust from the exhaust vent and the intake vent. 

15

AN-60KT

Ceiling Mount Bracket

AN-TK201

High Ceiling Installation

AN-TK202

Standard Ceiling Installation

Note

• 

The projector lens should be centred in the middle of the screen. If the horizontal line
passing through the lens centre is not perpendicular to the screen, the image will be
distorted, making viewing difficult.

• 

For optimal image, position the screen so that it is not in direct sunlight or room light.
Light falling directly on the screen washes out the colours, making viewing difficult. Close
the curtains and dim the lights when setting up the screen in a sunny or bright room.

16

• 

Place the projector at the required distance from the screen
according to the desired picture size.

• 

The

 

distance from the screen

to the projector may vary
depending on the size of the
screen. 

• 

The default setting can be
used, when placing the
projector in front of the
screen. If the projected image
is reversed or inverted,
readjust the setting to “Front”
in “PRJ Mode”.