DOWNLOAD Sharp XG-V10XE Service Manual ↓ Size: 1.25 MB | Pages: 63 in PDF or view online for FREE

13

 

• 

Press the lamp unit firmly into the lamp unit compartment.
Fasten the securing screws. 

 

• 

Insert the tab of the lamp unit cover into the opening, and
press the cover until it clicks in place. 

• 

If the lamp unit and lamp cover are not correctly installed, the
power will not turn on, even if the power cord is connected to
the projector.

• 

You need to reset lamp timer every time when replacing the lamp and confirm it to be
reset on “Lamp Timer” menu.

14

• 

Be sure to unplug the power cord before cleaning the projector.

• 

The cabinet as well as the operation panel is made of plastic. Avoid using benzene or
thinner, as these can damage the finish on the cabinet.

• 

Do not use volatile agents such as insecticides on the projector.
Do not attach rubber or plastic items on the projector for long time.
The effects of some of the agents in the plastic may cause damage to the quality or finish
of the projector.

 

• 

Wipe off dirt gently with a soft flannel cloth.

 

• 

When the dirt is hard to remove, soak a cloth in a neutral detergent diluted with water,
wring the cloth well and then wipe the projector.
Strong cleaning detergents may discolour, warp or damage the coating on the projector.
Make sure to test on a small, inconspicuous area on the projector before using.

• 

Use a commercially available blower or lens cleaning paper (for glasses and camera
lenses) for cleaning the lens. Do not use any liquid type-cleaning agents, as they may
wear off the coating film on the surface of the lens.

 

• 

As the surface of the lens can easily get damaged, be sure not to scrape or hit the lens.

• 

Use a vacuum cleaner to clean dust from the exhaust vent and the intake vent. 

15

• 

 This projector is equipped with air
filters to ensure the optimal
operating condition of the projector.

• 

The air filters should be cleaned
every 100 hours of use. Clean the
filters more often when the projector
is used in a dusty or smoky location.

• 

Ask your nearest Sharp Authorised
Projector Dealer or Service Centre
to exchange the filter (PFILD0110CEZZ) when it is no longer possible to clean.

• 

Press “STANDBY”. Wait until the cooling fan stops.

 

 

• 

Turn over the projector. Grab the tab and slide open the filter cover
in the direction of the arrow.

• 

Pick the air filter up with your fingers and lift it out of the filter cover.

 

16

• 

Place the air filter underneath the tabs on the filter cover.

 

• 

Slide the filter cover in the direction of the arrow to close it.

 

• 

Be sure the filter cover is securely installed. The power will not
turn on unless it is correctly installed.

• 

If dust or dirt has collected inside the bottom air filter (not
removable), clean the filter with a vacuum cleaner extension hose.