DOWNLOAD Sharp XG-NV6XE (serv.man4) Service Manual ↓ Size: 1.87 MB | Pages: 47 in PDF or view online for FREE

3-1. Remove the four lock screws off the top cabinet.
3-2. Unhook the top cabinet by pressing the center of both sides of the bottom cabinet as well as the hook on the

front (all marked with 

`

). Slowly lift the back of the cabinet and disconnect the operation key unit connector

(KY) and the speaker connector (SP). Then detach the top cabinet.

(KY)

(SP)

3-2

Top Cabinet

Operation Key Unit

3-1

3-1

`

`

`

4-1. Remove the five lock screws off the PC I/F unit. Lift and detach the unit off the output unit.
4-2. Disconnect the connectors from the output unit.
4-3. Remove the four lock screws off the output units. Remove also the lock screw off the ground fixture and

detach the ground fixture. Lift and detach the output, terminal and signal units.

(FD)

(IR)

(F)

(AZ)

(FE)

(EA)

(RP)

(BP)

(RI) (D)(Q)(L) (FA)(SO)(FB)

(GP)

4-1

4-2

4-3

4-3

PC I/F Unit

Terminal Unit

Signal Unit

Bottom Cabinet

Ground Fixture

Output Unit

Optical Mechanism Unit

Output Unit

5-1. Remove the two lock screws off the lamp socket holder. Detach the holder.
5-2. Disconnect the ground wire from the power unit.
5-3. Remove the six lock screws off the optical mechanism unit. Lift and detach the unit.

5-1

5-2

5-3

Optical Mechanism Unit

Duct Fan Unit

6-1. Disconnect the connector (BA) from the AC power switch.
6-2. Disconnect the ground wire from the inlet unit.
6-3. Remove the two lock screws off the ballast/filter/sound-out unit assembly. Detach the assembly.

7-1. Remove the three lock screws off the power PWB. Detach the power unit.

8-1. Remove the two lock screws off the AC power switch, disconnect the connector (PA) from the inlet unit, and

detach the AC power switch and the inlet unit.

(PA)

(BA)

6-1

6-2

6-3

7-1

8-1

to Inlet Unit  

Ballast/Filter/
Sound-Out Unit

Inlet Unit

Power Unit

AC Power Switch
(for Lamp replacement)