Sharp XG-C50XE (serv.man46) Service Manual / Technical Bulletin ▷ View online
LV068
Sharp Electronics (UK) Ltd., Technical Services Group
3.2 On the Tera Term Pro, select the “Setup” and then the “Terminal”.
Change “Receive” to “CR+LF” and then click “Local echo” to check.
Then click “OK”.
Then click “OK”.
3.3 Make sure that “ERR” is returned from the projector when you pressed the
ENTER key.
4. Call the process mode.
Press the following keys in this order.
POWER ON / Adj up / Adj down / Adj up / Adj down / ENTER / ENTER / MENU
POWER ON / Adj up / Adj down / Adj up / Adj down / ENTER / ENTER / MENU
5. Select the “SPECIAL” on the process menu and then press the ENTER key.
6. Select the “IPL2” on the sub menu and then press the ENTER key.
6. Select the “IPL2” on the sub menu and then press the ENTER key.
The lamp turns off and the projector goes into the software write mode.
7. Once unplug the AC cord and then plug it in again.
Note: Be sure to unplug the AC cord once and plug it in again.
LV068
Sharp Electronics (UK) Ltd., Technical Services Group
8. On the Tera Term Pro, enter the “RATE1152” and then press the ENTER key.
9. On the Tera Term Pro, select the “Setup” and then the “Terminal”.
click the “Local echo” to uncheck and then click the OK button.
LV068
Sharp Electronics (UK) Ltd., Technical Services Group
10. On the Tera Term Pro, select the “Setup” and then the “Serial port”.
Change the “Baud rate” to “115200” and then click the OK button.
11. On the Tera Term Pro, enter the “START” and then press the ENTER key.
Make sure that the “OK” is returned from the projector and the lamp indicator is
blinking in green.
blinking in green.
LV068
Sharp Electronics (UK) Ltd., Technical Services Group
12. On the Tera Term Pro, select the “File” and then the “Send file”.
Check the “Binary” in the Option and then select the
“pj_jffs_C50X_021203_1318.bwh” you decompressed.
Then click “open”.
“pj_jffs_C50X_021203_1318.bwh” you decompressed.
Then click “open”.
13. The transfer of data starts if the setting is correct. The “Bytes transferred” will be
counted in the dialog box.
14. Wait for several minutes until the “OK” is displayed two times and then the lamp
indicator is illuminated in red.
If the ERR is displayed, take the steps again from the step 1.
If the ERR is displayed, take the steps again from the step 1.
Display